© 2010 cisco systems, inc. all rights reserved.1 moca enabled home introduction and overview sooner...

© 2010 Cisco Systems, Inc. All rights reserved. 1

MoCA Enabled HomeIntroduction and Overview

Sooner State Chapter SCTE Meeting - TulsaApril 28, 2009

Jon CaveSenior Product ManagerCisco, Service Provider Video Technology Group


MoCA Overview

MoCA Troubleshooting Considerations

MoCA Installation Considerations

Future Potential with MoCA


Multimedia over Coax Alliance- MoCA

The Multimedia over Coax Alliance (MoCA) promotes and specifies delivery of digital entertainment and information content over the in-home coaxial cable

Established in 2004 – Over 50 Members

Leverage large installed base of Coax

Large Worldwide deployment base of MoCA enabled devices

Contributor

Members

Promoter

Members

Associate

Members


MoCA Technology Overview

MoCA technology allows for the interaction of devices across the typical Coax in a home - similar to how IP data networks operate.

Example - Whole Home DVR: Record programs on one device, and watch the program on another device in a different room.

MoCA enabled devices co-exist with delivered servicesVideo, High Speed Data, and Voice will co-exist with MoCA

MoCA Version 1.0 and Version 1.1 are releasedInitial MoCA STB deployments are using MoCA v1.0

Support for up to 125 Mbps Application Throughput270Mbps PHY rate

Packet error rate better than 1 x 10-5. 95% of outlets achieve greater than 100Mb/s Supports 8 MoCA nodes on the MoCA network

A Node in MoCA is similar to that in IP Networks


MoCA Physical Layer Operating Characteristics

MoCA Co-exists with CATV and DOCSIS

Coexistence with other services is required

Cable modem upstream 5-42 MHz

Cable operator downstream 55-850 MHz withexpansion up to 1 GHz

OFDM with Reed Solomon Forward Error Correction

7 Frequency Plans

A1 800 – 950 Mhz B1 850 – 950 MHz

C1 800 – 1050 Mhz C2 850 – 1075 Mhz

C3 850 – 1100 Mhz C4 875 – 1125 Mhz

D 1125 – 1525 Mhz (8 channels)

5 - 42 Upstream

54 – 860CATV

1000 - 1600MoCA1 GHz

MHz100 200 1000300 400 500 600 700 800 900 1100 1200 1300 1400 1500 16000


How do MoCA enabled devices work in the Home?


MoCA Works over Coax and Splitters

N:1 Splitter

Multi-Tap

Root Node300 Ft Multi-Tap to Root Node

300 Ft Root Node to Node

N:1 Splitter

TVSTB

TVSTB

N:1

Spl

itter

N:1 Splitter

MoCANode

TVSTB

MoCANode

TVSTB

MoCANode


Physical Layer - Logical

Logical Network is a Full Mesh Network Coordinator manages TDMA Broadcast and Multicast also supported

MoCANode

MoCANode

MoCANode

MoCANode

A Node in MoCA is similar to that in IP Networks


Whole Home DVR

Example usage of MoCA in the HomeExample usage of MoCA in the Home


IP Technologies and Open Standards

DTCP-IP

Multimedia over Coax Alliance™ “No New Wires” transmission technology

Utilizes in-home coaxial wiring

Allows for content, like HD video, to be distributed around the home (HD Whole Home DVR)

Digital Transmission Content Protection over IP™ Encryption technology standard embraced by studios & cable

Protect use of content distribution

Enables maximum content portability with DTCP-IP CE devices

Digital Network Living Alliance™ Standard that allows devices to connect, discover & communicate

with one another, over a home network


VoD

InternetVideo

Data

LinearVideo

CDS Vault TV Streamer

InternetStreamer

CDS ContentAcquirer

uBR CMTSBTS

DNCSH.264

EncodersSwitched

Digital Video

Headend / Hub

PCAdvanced

Set-Top Box

DOCSIS 3.0 modem

and Gateway

Media Enabled Home HD Whole Home DVR Centralizes network storage, while enabling standard non-DVR set-tops

to access DVR services

Reduces CapEx requirements and simplifies service

Monetizing the Connected Life: HD Whole Home DVR Example

Internet

LinearVideo

DNCSH.264

EncodersSwitched

Digital Video


VoD

InternetVideo

Data

LinearVideo


InternetStreamer

CDS ContentAcquirer

uBR CMTSBTS

DNCSH.264

EncodersSwitched

Digital Video

Headend / Hub

PCAdvanced

Set-Top Box

DOCSIS 3.0 modem

and Gateway

Media Enabled Home HD Whole Home DVR Centralizes network storage, while enabling standard non-DVR set-tops

to access DVR services



Internet

LinearVideo

DNCSH.264

EncodersSwitched

Digital Video

Record


VoD

InternetVideo

Data

LinearVideo


InternetStreamer

CDS ContentAcquirer

uBR CMTSBTS

DNCSH.264

EncodersSwitched

Digital Video

Headend / Hub

PCAdvanced

Set-Top Box

DOCSIS 3.0 modem

and Gateway

Media Enabled Home HD Whole Home DVR


Internet

LinearVideo

DNCSH.264

EncodersSwitched

Digital Video


VoD

InternetVideo

Data

LinearVideo


InternetStreamer

CDS ContentAcquirer

uBR CMTSBTS

DNCSH.264

EncodersSwitched

Digital Video

Headend / Hub

PCAdvanced

Set-Top Box

DOCSIS 3.0 modem

and Gateway



Internet

LinearVideo

DNCSH.264

EncodersSwitched

Digital Video

Play


VoD

InternetVideo

Data

LinearVideo


InternetStreamer

CDS ContentAcquirer

uBR CMTSBTS

DNCSH.264

EncodersSwitched

Digital Video

Headend / Hub

PCAdvanced

Set-Top Box

DOCSIS 3.0 modem

and Gateway


Benefits

Centralizes network storage, while enabling standard non-DVR set-tops to access DVR services



Internet

LinearVideo

DNCSH.264

EncodersSwitched

Digital Video


MoCA InstallationConsiderations


Installation Considerations Standard Install and Service Practices remain

in place when MoCA enabled Whole Home DVRs are deployed

Tap to TV Loss CalculationsConnectors Signal Level RequirementsCabling Splitters

MoCA Point of Entry (POE) Filter recommended as close as possible to premise entrance location to avoid potential for Home to Home interference and to improve in-home receive levels


Cisco MoCA Enabled Set-top Activation

The STB’s should automatically form a MoCA network after two or more MoCA devices boot up.

MoCA link indicator will illuminate after STB Boots on and the STB joins a MoCA Network.

Each STB is referred to as a MoCA node. A given STB refers to itself as the local node.


Point of Entry (POE) MoCA Filter

Prevents interference between MoCA homes on the same tap or Point of Entry

Minimizes MoCA energy on CATV feeder

Generally located at Residence Point of Entry (gnd. block) or at the TAP

Not recommended for self-install – installed by cable tech

Key Operating Characteristics – Passband 5 – 1002 MHz,

– Stopband -35 dB at 1125 – 1525 MHz

MoCA Server

MoCA Client

MoCAPOEFilter

Subscriber drop

Basic Installation

MoCA Server

MoCA client

Subscriber drop

Cable Modem

MoCAPOEFilter

Installation with Cable Modem


Aggressor Signal 50 dBmV

Victim Signal 50 dBmV

Server

Server

100 ft. RG-6100 ft. RG-6

-20 dBTAP

20 ft. RG-59

.

50 ft. RG-59

Client(degregated signal)

-30 dB 20 ft.

Home Interference Example without MoCA Filter

Home 1 Home 2

Feeder Line

To STB 1, 2, n

Interference travels from Home 1 to Home 2 MoCA Filters would block this interference


Installation of POE with Home Amplifier

Installation with Home Amp (Assumes Cable Modem does not have MoCA functionality).

Subscriber drop

MoCA Device

MoCA Device

X

Incorrect Installation: There must not be an amplifier between MoCA devices.

MoCA Device

MoCA Device

Subscriber drop

Cable Modem

MoCAPOEFilter



Basic Troubleshooting of Whole Home DVR Nodes:– Verify POE Installed correctly

• If used in your deployments.

– Verify Whole Home DVR can play recorded programs on the local unit and verify quality.

– Verify MoCA Node (STB in another room) can play recorded content and the video quality is the same as on Whole Home DVR.

– If Whole Home DVR and MoCA node do not play out recordings, a potential issue may exist in the network between the two devices.

– Leverage Whole Home DVR Diagnostics or Test Equipment to diagnose and isolate problems in the network.


Preliminary Cisco Whole Home DVR MoCA Diagnostics

Node Summary and Network Page

Summary: Node and Network Information

Status: Verify status is Link up, indicating that the node has successfully joined the network.

Broadcast PHY rate: Wait at least 30 seconds after Link Up is achieved. Verify Broadcast PHY rate is at least 150 Mbps (this parameter will be available in a future software release).

Diagnostic Screen is Preliminary and Subject to Change



Node Statistics

Unicast PHY rates: Verify that Unicast PHY rates to other nodes are all at least 180 Mb/s.

Broadcast PHY rates: The Broadcast PHY rate of each node is visible. Verify that Broadcast PHY rates are at least 150 Mb/s

Local node RX level: Verify that receive levels from other nodes are all -54dBm or greater.

Approx Path Loss: This parameter is not needed for performance verification, but is useful for compiling data on path loss in homes. As a general guideline, path loss should be 54 dB or less.




MoCA Interface Info Page

Verify that the MoCA IF IP and MoCA IF mask have been assigned.

Verify that the TX Pkts and Rx Pkts are incrementing (screen refreshes every 5 seconds)



Options for handling Low Local node RX level

MoCA Device

MoCA Device

Subscriber drop

Cable Modem

movePOEFilter

Moving POE filter to reduce MoCA signal loss. (Assumes Cable modem is not a MoCA device).


With a MoCA enabled home, the potential is endless….


Next Generation Home SystemExample: Ubiquitous Content Access

HOMEInternet

MoCAOutside

TheHome

PC

Multi-Media Service Gateway

Next GenWH-DVR

PhotosFrom PC

DVR contentOver the Internet

Stored musicIn any room

Internet video

On HDTV

Multi-MediaClient Gateway

Multi-MediaClient Gateway

PhotosFrom PC

Next GenMR-DVR

Stored musicIn any room

Internet video

On HDTV

DVR contentOver the Internet Network

Ethernet

Home ServicesGateway


Thank You!

© 2010 cisco systems, inc. all rights reserved.1 moca enabled home introduction and overview sooner...

Documents

moca moca version

moca slide

moca network

moca v1

moca works

moca nodes

coax alliance moca

coax alliance moca