USER CUSTOMIZATION GUIDE FOR 10CM FSLP

10cm ACTIVE LENGTH

Step: 1 (Refer to Fig. 2.)Align cutting tool along the top edge of the sensor and at the base ofeach tab to be cut. Carefully cut across Tab 1, Tab 2 and Tab 3.

75mm ACTIVE LENGTH

Step: 1 (Refer to Fig. 1.)Align cutting tool at the 75mm “ ” notch position and the left edge of Tab 1, as shown in the picture. Carefully cut across the sensor in a singlemotion. Do not cut repeatedly over the same area. Doing this may cause permanent damage to the sensor!

Step: 2 (Refer to Fig. 3.)Align cutting tool along the top edge of the sensor and at the base of each tab to be cut. Carefully cut across Tab 2 and Tab 3.

BASE “NON-FUNCTIONAL” FSLP SENSOR

The base version of the FSLP sensor is provided in a non-functionalstate. Depending on the application, the base sensor can be customizedto yield 4 different active length options. Custom lengths can be achieved by cutting to the desired active length along the “ ” notch (see Fig. 1). For example, if a 75mm active length is required, align the cutting tool along the 75mm position. Also, depending on what length is required, some or all of the tabs may need to be cut to allow proper functionalperformance.

Tab 1

75

mm

50

mm

25

mm

Tab 2 Tab 3

“ ” notch(3 PL)

Fig. 1

Tab 1 Tab 2 Tab 3Fig. 2 Step: 1

Fig. 4

NOTE: TAB 2 MUST NOT BE CUT!

Tab 2 Tab 3

Step: 1

Step: 2

50mm ACTIVE LENGTHStep: 1 (Refer to Fig. 1.)Align cutting tool at the 50mm “ ” notch position and the left edge of Tab 2, as shown in the picture. Carefully cut across the sensor in a single motion. Do not cut repeatedly over the same area. Doing thismay cause permanent damage to the sensor!

Step: 2 (Refer to Fig. 4.)Align cutting tool along the top edge of the sensor and at the base of each tab to be cut. Carefully cut across Tab 3.

Fig. 3

NOTE: TAB 1 MUST NOT BE CUT!

Tab 1 Tab 2 Tab 3

Step: 1

Step: 2

25mm ACTIVE LENGTH

Step: 1 (Refer to Fig. 1.)Align cutting tool at the 25mm “ ” notch position and theleft edge of Tab 3. Carefully cut across the sensor in a single motion. Do not cut repeatedly over the same area. Doing this may cause permanent damage to the sensor!

Fig. 5 shows the a 25mm active area finished sensor.

Fig. 5 Tab 3

Step: 1 NOTE: TAB 3 MUST NOT BE CUT!

P/N: 94-00038 REV. A