ignis adl 350.pdf

8/10/2019 IGNIS ADL 350.pdf

1/8

GB -1-

Chart

PROGRAMME SELECTION BUTTONPress button P (repeatedly) until the indicator of the req uired programme lights

up (see Table of programmes below).

ONBUTTON

OFFBUTTON

START BUTTONThe indicator lights up during operation, flashes when a fault occurs and goes off atthe end of the programme.

START BUTTON RESET FUNCTIONPress this button for at least 2 seconds; the selected programme and options arecancelled. Main failure displays (repeated flashing of the STARTindicator lamp) can be

cancelled by RESETTING. Detailed instructions are given in chapter What to do if....

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additionaloptions) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result ofthe appliances automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed informationon the EN/Standard loading comparison test and other tests, contact the following address: [email protected].

Table of programmes

Detergent

Consumption

P Programmes Loading instructions Litres kWh Minutes1)

1 Pre-Wash cold Crockery to be washed later. 5.0 0.02 10

2 Quickwash 40CLightly soiled crockery, with nodried-on food. * Use of tablets notrecommended.

X * 13.0 0.70 30

3 Bio2) 50CNormally soiled crockery. Energysaving programme with prolongeddrying cycle.

X 16.0 1.05 195

4 Daily 60C Normally or heavily soiled crockery. X 16.0 1.35 120

5 Intensive 70CRecommended programme forheavily so iled crockery, especiallysuitable for pots and pans.

X 17.0 1.65 145

5019 596 01519ADL 350

BEFORE USING THE APPLIANCE FOR THEFIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATIONINSTRUCTIONS! THE GUARANTEE IS NOTAPPLICABLE IF FAULTS ARE CAUSED BYINCORRECT USE OF THE APPLIANCE.

Quick reference guide


2/8

GB -2-

First time use

1- salt reservoir

2- rinse aid dispenser

3- detergent dispenser

4- racks system

5,6,7,8- available functions on the panel

9- filters

10- spray arms

In order to always ensure the best cleaningresults, you NEED to set:DETERGENT type and WATER HARDNESS.

1.Select 3rd programme(see Table o f programmes- page 1)

2. Pre ss START buttonfor 7 seconds

3a.Check yourdetergent type...

3b....and set it on your dishwasherusing the START button(as per t able below)

4. Remember to use salt and rinseaid w hen needed (as indicatedbelow)

5. Switch off and switch onagain to save sett ing

Detergenttypes

Dishwasher models

model withoutdisplay

model w ith display

Powder or gel(factory setting)

no symbol add salt add rinse aid

Tablet 2 in 1 add salt

Tablet 3 in 1

Tablet All in 1

For models without detergent t ype o ption, the salt and rinse aid indicators w ill be lit when t ablets are used.

3h 6h 9h

rinse aid

salt rinse aid

1. Ask your wat er supply company w hatthe water hardnessis...

2. . . .enter this value on your dishwasher Suggestions for detergent use

Englishdegrees eH

Waterhardness

Dishwasher withdisplay: insert value

in the display

Dishwasher withoutdisplay: count

START butt on led

flashes

Gel or Powder(rinse aid and salt)

Tablets

0 - 6.3 Soft 1 1x

go to step 1

(see D aily check)

if extra salt is

needed go to step 1(see D aily check)

7 - 12.6 Medium 2 2x

13.3 - 18.9 Average 3 3x

19.6 - 25.9 Medium-hard 4 4x

26.6 - 35 Hard 5 5x

35.7 - 44.1 Very hard 6 6x

44.8 - 74.9 Extremely hard 7 7x

How to set water hardness

*only before the first washor if thewater hardness has been changed

Switch on the appliance

- Select the 2nd programme P2 - consult the table of programmes.- Press the START button for at least 5 seconds until the START indicator lamp flashes.- The w ater hardness setting is shown on t he display (if present) or the START button flashes.- With each successive touch of the START button t he setting increases and w hen it reaches 7 it returns to 1 again.- The appliance must be switched off to memorise the new setting.

Even if you use tablets which include salt,you must still add sa lt since suchdetergents are not effective enough atsoftening hard w ater.

Water hardness level is factory set formedium hard water (a number 4 isshown on the display or the STARTindicator lamp flashes 4 t imes).

How to set detergent type: powder/gel/tablet (if option is available)


3/8


4/8

GB -4-

How to load the racks

H

J

(depending on the model)

G - Foldable plate holders:They can be folded down to load pot sor

H- Fixed plate holders

I - Cutlery basket (orJmodel)

K - Grid:Helps to keep the cutlery separate for better washing results.

I

How to load LOWER RACK

4

(In some models only)

A - Multipurpose support:Different positions for long

utensils, cups and glasses.

B - Adjustable flaps:In horizontal position for cups/long utensils,in raised position for plates a nd stemware.

(In some models only)

C - Cutlery basket:It can be placed in the upper rack when the

Half load/Multizone is selected.D - Adjustable glass holder

How to adjust upper rack height(if available)

- It could be useful to lift up upper rack to have more space inlower rack or bring it do wn to load long stem glasses.

- Grasp and take out the tw o lateral handles (E) (must be on samelevel) and lift up or take down the upper rack.

How to remove upper rack (if available)

- It could be useful to remove upper rack to load bulky items inlower rack.

- Open the two retainers (F) to take off the upper rack. Whenthe upper rack is in place the retainers must always be closed.

Arrange crockery so t hat w ater does not collect in cavities, ensuring that t he spray arms turn freely. O nly use dishwasher-proof crockery and dishes. D o not use the dishwasher for washing wo oden

items, aluminium, tin, silver cutlery or decorated crockery (unglazed). In the baskets, dishes (e.g. plates, bow ls, pot s) must be placed in a correct way to let water flow dow n!

F- CLOSED F- OPEN

Switching on the appliance

How to load UPPER RACK

5


5/8

GB -5-

Switch off the appliance Everything o.k. ...

Wash cycle

Select programme Quick, permanent or alternating

6

7

8Exercise caution w hen opening the door: beware of hot steam.

Only press the OFF button once the START indicator lamp has switched off.

All the indicator lamps switch off. Unload the appliance, sta rting from the lower rack in order to avoid any residual drips of wat er falling onto crockery below .

Maintenance and careMaintenance and care

Change the programme in progress:

Press the START button (for 2 seconds) until the START indicator lampswitches off.

Close the door.

(Water drains for up to 60 seconds).

Open the door.

Select a new programme.

Press the START button.

Overview of programmes

The max. possible number of programmes is illustrated in the chapter Chart. The corresponding programmes for your appliance can be found on the panel (page 1).

Choo se programme according to the att ached table of programmes (page 1).

Duration of t he programme depends on the external conditions in the apartment, temperature and pressure et c.

The dishwasher door must be closed and the w ater t ap open.

To load cro ckery, open the doo r w ith caution:

Close the door again.

The programme resumes the cycle from w here it w as interrupted.

Beware of hot steam!

The wash cycle can be interrupted at any time by START (see chapter What to do if ).

Rectifying minor faults yourself ...

10

9FiltersCheck andclean ifnecessary

Unscrew filtercylinder, remove itand fine sieve...

Rinse under runningwater ...

Screw on filter cylinder NO TE MARK!

Unscrewand removeupper arm .. .

Spray armsRemoveblockages/deposits.

Insert

Clean spraynozzles underrunning w ater(use too thpicks ifnecessary) ...

Insert and screw on low er and upper arms t ightly.

Unscrewand removelow er arm ...


6/8


7/8


8/8

ignis adl 350.pdf

Documents