hv probe nat 111 4018 hv reference cableat 111 4056
TRANSCRIPT
Objednací číslo AT 505 5001
ATAL spol. s r.o. Lesní 47, Tábor - Horky, 390 01, Czech Republic Phone: +420 381 251 791, Fax: +420 381 253 043
e-mail: [email protected]; web: http://www.atal.cz
HHHVVV PPPrrrooobbbeee NNN ............................................................................................................AAATTT 111111111 444000111888 HHHVVV RRReeefffeeerrreeennnccceee cccaaabbbllleee.....................................................................AAATTT 111111111 444000555666
„HV probe N“ is used for measuring of the high voltage on the spark plugs by fitting the vehicle HV cable.
Option for Multi-Diag Scope
Multi-make Diagnostics Reference AT 111 4018, AT 111 4056
HV-probe-N-prospectus-en.doc The right is reserved to change this document (text and photos) ref.P111 0318
29.6
.201
1
During measuring on HV cables, when is required measuring of flashover voltage, is necessary insert the “High-voltage reference cable” between ignition cable and spark plug. At this „HV Reference cable“ then put „HV probe N“ (see figure below).
Measurement of high voltage on one cylinder with a high voltage cables with „HV probe N“
and „HV Reference cable“
Ground High Voltage probe N
High Voltage probe N
High Voltage Reference cable
High Voltage cable
Technical parameters HV probe N - AT 111 4018 HV probe C1 - AT 111 4017
±10% z MV ±15% z MV
Measurements of the High Voltage reference cable AT 111 4056
High voltage Voltmeter in oscilloscope
HV probe N - AT 111 4018 HV probe C1 - AT 111 4017
0 ... 25 kV 0,1 kV
±20% z MV ±30% z MV Measurement of the commonly used high-voltage cables
MV: measured value
Ground High Voltage probe N
High Voltage probe N
High Voltage cable
Measurement of high voltage on one cylinder with a high voltage cables with „HV probe N“