feedback amplifiers subject : advance electronics by ronak gadaria 1
TRANSCRIPT
Feedback AmplifiersFeedback Amplifiers
Subject : Advance Electronics
By Ronak Gadaria 1
IntroductionIntroduction
When the part of output is sampled & fed When the part of output is sampled & fed back to the input of amplifier.back to the input of amplifier.
Input & part of output which is fed back to Input & part of output which is fed back to the inputthe input◦ Positive Feedback (In phase) +Positive Feedback (In phase) +◦ Negative Feed back (Output of Phase) - Negative Feed back (Output of Phase) -
Improve its performance & to make it more Improve its performance & to make it more ideal.ideal.
+ve Feedback results in oscillators & +ve Feedback results in oscillators & hence not used in amplifiers.hence not used in amplifiers.
By Ronak Gadaria 2
Classification of Classification of AmplifiersAmplifiers
Classification of amplifiers based on the Classification of amplifiers based on the mag. of input & output imp. of an amplifier mag. of input & output imp. of an amplifier relative to the source & load impedance, relative to the source & load impedance, respectivelyrespectively
Voltage Amplifier (VVoltage Amplifier (Voo/V/Vii))Current Amplifier (ICurrent Amplifier (Ioo/I/Iii))Transconduction Amplifier (ITransconduction Amplifier (Ioo/V/Vii))Transresistance Amplifier (VTransresistance Amplifier (Voo/I/Iii))
By Ronak Gadaria 3
Voltage AmplifierVoltage Amplifier
Thevenin’s equivalent circuit of V AThevenin’s equivalent circuit of V ASuch amplifiers will provide a voltage Such amplifiers will provide a voltage
output resistance proportional to voltage output resistance proportional to voltage input.input.
By Ronak Gadaria 4
Current AmplifierCurrent Amplifier
Norton’s equivalent circuit of C ANorton’s equivalent circuit of C AProvides a current output proportional to Provides a current output proportional to
input.input. An ideal C A must have zero input resi. & An ideal C A must have zero input resi. &
infinite output resi.infinite output resi.
By Ronak Gadaria 5
Trans conductance AmplifierTrans conductance Amplifier
Provides a current output proportional to Provides a current output proportional to input voltageinput voltage
Ideally in this amplifier has infinite input Ideally in this amplifier has infinite input resistance & infinite output resistancresistance & infinite output resistancee
By Ronak Gadaria 6
Trans resistance AmplifierTrans resistance Amplifier
Provides a voltage output Provides a voltage output proportional to input Currentproportional to input Current
Ideally in this amplifier has zero Ideally in this amplifier has zero input resistance & zero output input resistance & zero output resistanceresistance
By Ronak Gadaria 7
Block diagram of amplifier Block diagram of amplifier with feed backwith feed back
By Ronak Gadaria 8
Comparator or
mixer network
Sampling
network
Basic Amp. Forward
transfer Gain A
FB n/w reverse Transmission
β
Signal Source
Sampling NetworkSampling Network
Voltage or Current or Node Sampling Loop Sampling
By Ronak Gadaria 9
Mixing NetworkMixing Network
Series Mixing Shunt MixingVf
= β V0
By Ronak Gadaria 10
Transfer Ratio or GainTransfer Ratio or Gain
Ratio of Output signal to input is denoted by A
By Ronak Gadaria 11
Schematic Representation of Schematic Representation of negative Feedback systemnegative Feedback system
By Ronak Gadaria 12
Voltage Amplifier with Voltage Amplifier with voltage series Feedbackvoltage series Feedback
By Ronak Gadaria 13
Trans conductance Amplifier Trans conductance Amplifier with Current series Feedbackwith Current series Feedback
By Ronak Gadaria 14
Current Amplifier with Current Shunt Current Amplifier with Current Shunt FeedbackFeedback
By Ronak Gadaria 15
Transresistance Amplifier Transresistance Amplifier with Voltage Shunt Feedbackwith Voltage Shunt Feedback
By Ronak Gadaria 16
By Ronak Gadaria 17
Parameters of –ve Feed Back Parameters of –ve Feed Back AmplifierAmplifier
Transfer Gain with FBLoop Gain or Return GainDe-sensitivity of GainCut off frequency with FB
◦Lower cut off frequency◦Upper cut off frequency
Distortion with FBInput & output Resistance
18By Ronak Gadaria
Transfer Gain of FeedbackTransfer Gain of Feedback
19
Loop Gain or Return RatioLoop Gain or Return Ratio
The gain of the loop is –Aβ
Difference between unity & loop gain is
called as return difference. D = 1+Aβ
The amount of the feed back introduced
into an amplifier can be expressed on (dB)
For Negative FB, N will be negative.
By Ronak Gadaria 20
De-sensitivity of GainDe-sensitivity of Gain
Transfer gain is not constant as it depends upon the factors such as operating point, temperature etc.
This lack of stability in amplifiers can be reduced by introducing negative FB.
By Ronak Gadaria 21
By Ronak Gadaria 22
This ratio is called sensitivity of the transfer gain
The reciprocal of the sensitivity is called the De sensitivity. D = 1+Aβ
Thus stability of amplifier increases with increase in de sensitivity.
Aβ >>1 then,
Amplifier Gain is dependent only on gain of the feedback network.
By Ronak Gadaria 23
By Ronak Gadaria 24
Cut off frequencies with Cut off frequencies with FeedbackFeedback
By Ronak Gadaria 25
Lower cut off frequencyLower cut off frequency
By Ronak Gadaria 26
By Ronak Gadaria 27
By Ronak Gadaria 28
Upper cut off frequencyUpper cut off frequency
By Ronak Gadaria 29
By Ronak Gadaria 30
BandwidthBandwidth
By Ronak Gadaria 31
Distortion with FeedbackDistortion with Feedback
we can say that if the feedback network does not contain reactive elements, the overall gain is not a function of frequency.
Frequency and phase distortion is substantially reduced.
In tuned amplifiers, feedback network is designed such that at tuned frequency β tends 0 and at other frequencies β tends infinity.
By Ronak Gadaria 32
Noise & Nonlinear DistortionNoise & Nonlinear Distortion
Signal feedback reduces the amount of noise signal and nonlinear distortion.
The factor (1+Aβ) reduces both input noise and resulting nonlinear distortion for considerable improvement.
Thus, noise and nonlinear distortion also reduced by same factor as the gain.
By Ronak Gadaria 33
Input ResistanceInput Resistance
Vf opposes Vs, input current Ii is less than that of without Feed back.
Rif is greater then that of Ri of without FB
By Ronak Gadaria 34
The current Is, drawn from the signal source is increased over what it would be if There were no feedback current.
Rif is Lesser then that of Ri of without FB
By Ronak Gadaria 35
Input resistance of Voltage series Input resistance of Voltage series FeedbackFeedback
By Ronak Gadaria 36
By Ronak Gadaria 37
Input Resistance of current series Input Resistance of current series feedbackfeedback
By Ronak Gadaria 38
Input resistance of current shunt Input resistance of current shunt feedbackfeedback
By Ronak Gadaria 39
Input resistance of Voltage shunt Input resistance of Voltage shunt feedbackfeedback
By Ronak Gadaria 40
Output ResistanceOutput Resistance
The negative feedback which samples the output voltage, regardless of how this output signal is returned to the input, tends to decrease the output resistance
By Ronak Gadaria 41
On the other hand, the negative feedback which samples the output current, regardless of how this signal is returned to the input, tends to increase the output resistance.
By Ronak Gadaria 42
Output resistance of Voltage series Output resistance of Voltage series feedbackfeedback
By Ronak Gadaria 43
By Ronak Gadaria 44
By Ronak Gadaria 45
Output Resistance of Voltage shunt Output Resistance of Voltage shunt FBFB
By Ronak Gadaria 46
Output Resistance of Current shunt Output Resistance of Current shunt FBFB
By Ronak Gadaria 47
By Ronak Gadaria 48
Output Resistance of Current series Output Resistance of Current series FBFB
By Ronak Gadaria 49
By Ronak Gadaria 50
Advantages of Negative Advantages of Negative FeedbackFeedback
Input Impedance Increased by factor (1+Aβ)
Output Impedance Reduced by factor (1+Aβ)
Gain Stability : The transfer gain Af of amp with feedback can be stabilized against variations of the h-para of transistor
Increased bandwidth by a factor (1+Aβ).Reduced non linear distortionReduced noise by a factor (1+Aβ)
By Ronak Gadaria 51
Disadvantage of Negative Disadvantage of Negative FeedbackFeedback
All the advantages mentioned above are obtained at the expense of the gain Af with Feedback, which is lowered in comparison with the transfer gain A of an amplifier without feedback by a factor (1+Aβ).
A negative feed back amplifier is designed for the particular range of frequency. It may break out in to oscillation at some high or low frequency.
By Ronak Gadaria 52
By Ronak Gadaria 53
Method of identifying feedback Method of identifying feedback topology and analysis of a topology and analysis of a
feedback amplifierfeedback amplifierStep:1 Identify Topology (Type of Feedback)
A) To find out the type of feedback (Sampling)1 By shorting the output i.e. V0=0, if feedback signal(xf)
becomes zero then we can say that is “Voltage Sampling”
2. By shorting the output loop i.e. I0 = 0, if feedback signal(xf) becomes zero then we can say that is “Current Sampling”
B) To find the type of mixing network1. If the feedback signal is subtracted from the externally
applied signal as a voltage in the input loop, we can say that it is “Series mixing”
2. If the feedback signal is subtracted from the externally applied signal as a current in the input loop, we can say that it is “Shunt mixing”
By Ronak Gadaria 54
Step 2 : Find the input circuit1. For voltage sampling make V0 = 0 by shorting the
output2. For current sampling make I0 = 0 by shorting the
outputStep 3: Find the output circuit
1. For series mixing make Ii= 0, by opening the input loop.
2. For shunt mixing make Vi = 0, by shorting the input
Step 2 & Step 3 ensure that the feedback is reduced to zero without altering the loading on the basic amplifier.
By Ronak Gadaria 55
Step 4 : Optional. Replace each active device by its h-parameter model at low frequency.
Step 5 : Find out open loop gain (gain without feedback), A of the amplifier.
Step 6: Indicate Xf and X0 on the circuit and evaluate β = Xf/X0
Step 7: From A and β Af, Rif, Rof and R’0f
By Ronak Gadaria 56
Voltage Series FeedbackVoltage Series Feedback
Emitter FollowerVo i.e. Vf i.e.
Voltage across Re increase
• VBE Decrease
• Hence –ve FB
By Ronak Gadaria 57
Input & Output Circuit
By Ronak Gadaria 58
H model of Transistor
By Ronak Gadaria 59
By Ronak Gadaria 60
Current Series FeedbackCurrent Series Feedback
By Ronak Gadaria 61
Input and output circuit
By Ronak Gadaria 62
H model of Feed back Amp.H model of Feed back Amp.
By Ronak Gadaria 63
By Ronak Gadaria 64
By Ronak Gadaria 65
By Ronak Gadaria 66
By Ronak Gadaria 67
Voltage series Feedback pairVoltage series Feedback pair
By Ronak Gadaria 68
By Ronak Gadaria 69
By Ronak Gadaria 70
By Ronak Gadaria 71
R3 R4
By Ronak Gadaria 72