04/19/23 07:01
without barcode reader
2.
Select „Easy preparation“.
Click OK.
1.
Start PrepGilsonST program
with a double click.
04/19/23 07:01
without barcode reader
4.
Initialize the Gilson® robot by pressing the green button.
The status changes to „home seeking“.
The Gilson® robot is
initialized.
04/19/23 07:01
without barcode reader
5a.
Delete a rack
In „Edit mode“ double click on a grey area within a rack field.
The program asks, if the selected rack shall be deleted. Click „Yes“.
04/19/23 07:01
without barcode reader
5b.
Insert a new rack
Double click on an empty rack area.
Select the used rack type.
04/19/23 07:01
without barcode reader
5b.Insert a new rack
ID Barcode:Enter the new barcode ID, e.g. ABC0033#NMR
Type Barcode:Select the Starting corner and pattern. The barcode type is a combination of the rack name, the starting corner and the pattern.
Click OK.
04/19/23 07:01
without barcode reader
5b.
Insert a new rack
Click „Save Tray“ and uncheck „Edit mode“.
04/19/23 07:01
without barcode reader
6.
Check or select the appropriate procedure and solvent.
Now it is possible to set up orders.
04/19/23 07:01
without barcode reader
7. Defining the source rack
• Click the „Source“ button.
• Select the source tubes with a lasso operation:
• Click and hold the left mouse cursor. Draw a rectangle.
• The marked positions will be shown as orders.
04/19/23 07:01
without barcode reader
7. Defining the source rack
Tip:
• Use the Ctrl Key and left mouse key to select variable sources.
04/19/23 07:01
without barcode reader
• The marked positions will be shown as orders with their destination.
• Select the destination tubes with a lasso operation:
Click and hold the left mouse cursor. Draw a rectangle.
8. Defining the destination rack
• Click the „Destination“ button.
04/19/23 07:01
without barcode reader
Tip:
• Use the right mouse key to zoom in and out.
• Use the Ctrl Key and left mouse key to select variable sources.
04/19/23 07:01
without barcode reader
9.
Click the button „Create Orders“.
All „Created Orders“ are listed.
Click OK.