analysis steps for abacus static analysis geneva wheel

7/25/2019 Analysis Steps for Abacus static analysis Geneva wheel

1/8

The mesh, material and property is created in hypermesh.

Import the fle to abacus.

Under Module-Property, you can see stell is assigned

Next, goto tools- reerence points. i!e ",#,$ !alues at the bottom as.

%,-&',% and hit enter

(gain gi!e )%.'&*,-&+.',% and hit enter. It ill create reerence points

as shon belo.

reate * sets o elements o both dri!er and dri!en.

oto Interaction manager / create / surace to surace-


2/8

0elect by angle gi!e 1% and select as shon the regions here

interactions happen 2use shit 3ey to select 4 and done. Next clic3 on

sla!e and select the dri!en gear contact regions as shon belo,

(ter that


3/8

ontact interaction property - 5it create- contact-mechanical-

tangential beha!ior- riction ormulation-penalty- ric coe6 7 %.&


4/8

o to constraints / MP constraints- continue / clic3 geometry and pic3

8P& o dri!en

lic3 on mesh / select region or sla!e nodes / indi!idually / 0elect

completely using shit 3ey- 9one


5/8

9o the same ay or dri!er gear.


6/8

:oad- ;oundary condition manager / clic3 geometry, select 8P& and

chec3 U&, U*, U


7/8

9ouble clic3 on propogated in step * and gi!e ).*' radians as shon

Next, Tools- set / manager- create / static general / continue

Nl geom on

hange increment as shon belo

(gain create / static general / step * and repeat till step ).

i!e same initial, min and maximum !alues as shon abo!e or next )

steps.


8/8

o to feld o=p manager in module / step. 0econd option

9ouble clic3 >ust belo step * and select ?orce=displacement rom the

dialogue box. hec3 8?orce and 8M orce and o3.

8un the model

analysis steps for abacus static analysis geneva wheel

Documents