preform thickness gauge - plastico.com

Automatic measurement for material concentricity of PET and PET/PEN preforms

PTG0213

Computer not included

● Eliminate hand measurement errors

PreformThickness GaugePTG5004

Agr® and Agr•TopWave® are registered trademarks of Agr International, Inc.

● Increase sampling rate

● Detect core defects

● Improve profitability

OPERATING PRINCIPLEThe device non-destructively measures the material concentricity, always at the same predetermined locations,thus providing repeatable and reproducible results. The sample is simply inserted into the measurement cell that is equipped with four ultrasonic sensors and a universal preform fixture. The screen display will prompt the operator when to insert and remove the preform from the measurement cell. When activated, all of the sensors measure simultaneously and the results are instantly transmitted to your PC. Upon removal, the measurement results are displayed on the screen.

SPECIFICATIONS

Power Supply: 100V-240V Auto switching Weight: 32 lbs (15kg) Size (w/d/h): 13.4 inches X 24.4 inches X 4.8 inches (340mm X 620mm X 121mm) Measurement method: Multi-channel ultrasonic gauge Vertical Measurement range: 0.39 - 0.98 inches (10-25mm) from bottom of preform Sample Measurement range: Height: 2.0 - 9.84 inches (50-250mm) Diameter: 0.7 - 2.0 inches (18-50mm) Wall Thickness: 0.060 - 0.275 inches (1.5-7.0mm) Operation: Automatic, non-destructive Sensors: 4 immersion-type transducers Location: 0.59 inch (15mm) from the bottom of sample (nominal) Cycle time: 3 to 5 sec/sample Resolution: 10um/0.4mil

Agr reserves the right to alter design and/or specifications without

notification.

FEATURES● Simple operation● Measurement results in seconds● Measures up to 0.276 inch (7mm) thick preforms● Non-destructive test method● Accurate repeatable and reproducible results● RS232-connection● Compatible with Windows 7 and 8● Selectable units of measurement

Material concentricity is one of the most common and critical measurements performed on injection molded PET and PET/PEN preforms. Proper preform concentricity leads to good bottle quality thus reducing problems associated with poor thickness distribution, off-center gates, bottom rupture, and perpendicularity.

Agr International, Inc. ● Butler, PA USA ● Phone +1-724-482-2163 ● Fax: +1-724-482-2767 ● www.agrintl.com