portfolio (design engineering)

DAVID DIAZMechanical Engineer

PORTFOLIODesign Engineering

Samples

PORTFOLIOSome Samples

Bolt Torque Calculation SheetDevelopment Engineer

DFSS Project: “Low Cost Step”Project Leader and Design Engineer (PRO-E/Creo)

Tooling, Equipment and FixturesDesign Engineer (SolidWorks)

Sheet Metal PartDesign Engineer (SolidWorks)

FIXTURE GO/NOGO

DIMENSIONS TO CHECK IN PRODUCT

INSERT PART

PART MUST GO TO THE END

MOVE LEVER

IF PART DOES NOT ENTER,BECAUSE GO/NOGO TOUCHESTHE MARKED AREAS, DIMENION“A” IS OUT OF TOLEARANCE (-)

IF PART DOES NOT ENTER,BECAUSE GO/NOGO TOUCHESTHE MARKED AREAS, DIMENION“A” IS OUT OF TOLEARANCE (+)

IF PART DOES NOT ENTER,BECAUSE GO/NOGO TOUCHESTHE MARKED AREAS, DIMENION“B” IS OUT OF TOLEARANCE (+)

IF PART DOES NOT ENTER,BECAUSE GO/NOGO TOUCHESTHE MARKED AREAS, DIMENION“B” IS OUT OF TOLEARANCE (-)

FAILURE ANALYSIS IN PRODUCTDesign Engineer (SolidWorks)

Documents