the beatles rock band hofner bass whammy bar … · the beatles rock band hofner bass whammy bar...

6
The Beatles Rock Band Hofner Bass Whammy Bar Replacement This guide will demonstrate how to replace the whammy bar in the guitar. Written By: Jacob The Beatles Rock Band Hofner Bass Whammy Bar Replacement © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 6

Upload: vuduong

Post on 12-Jul-2018

299 views

Category:

Documents


0 download

TRANSCRIPT

  • The Beatles Rock Band Hofner Bass WhammyBar Replacement

    This guide will demonstrate how to replace the whammy bar in the guitar.

    Written By: Jacob

    The Beatles Rock Band Hofner Bass Whammy Bar Replacement

    iFixit CC BY-NC-SA www.iFixit.com Page 1 of 6

  • INTRODUCTION

    In this guide you will learn how to replace the whammy bar in a Rock Band Beatles Hofner Bass.

    TOOLS:JIS Driver Set (1)

    The Beatles Rock Band Hofner Bass Whammy Bar Replacement

    iFixit CC BY-NC-SA www.iFixit.com Page 2 of 6

    http:/IF145-115-1

  • Step 1 Back Plate

    Flip the bass onto its backside, sothat the strummer is facing the tableand the battery compartment isfacing you.

    Use a J1 Phillips head screwdriverto remove ten 5mm short screws.

    Use a J1 Phillips head screwdriverto remove four 5mm long screws.

    Step 2

    Flip the bass to the front, with thestrummer and fret buttons facingyou.

    Use a J1 Phillips head screwdriverto remove two 10mm silver, shortscrews.

    The Beatles Rock Band Hofner Bass Whammy Bar Replacement

    iFixit CC BY-NC-SA www.iFixit.com Page 3 of 6

  • Step 3

    Flip the bass on its back again, so that the strummer is facing down and the battery compartmentis facing you.

    Pull off the back whole panel so that the bass is now open.

    Step 4 Whammy Bar

    Use J1 Phillips screwdriver toremove the four 10mm screws onthe whammy bars black cover.

    The Beatles Rock Band Hofner Bass Whammy Bar Replacement

    iFixit CC BY-NC-SA www.iFixit.com Page 4 of 6

  • Step 5

    Remove the black cover.

    Now the white whammy barunderneath is visible.

    Step 6

    Use a J1 Philips head screwdriver to remove one 10mm screw.

    This will unscrew the electrical connection between the whammy bar and the blue circuit board.

    Remove the electrical connector.

    The Beatles Rock Band Hofner Bass Whammy Bar Replacement

    iFixit CC BY-NC-SA www.iFixit.com Page 5 of 6

  • To reassemble your device, follow these instructions in reverse order.

    This document was last generated on 2017-07-02 01:39:25 AM.

    Step 7

    Remove the whammy bar, sincenothing should be connecting to theguitar anymore.

    The Beatles Rock Band Hofner Bass Whammy Bar Replacement

    iFixit CC BY-NC-SA www.iFixit.com Page 6 of 6

    The Beatles Rock Band Hofner Bass Whammy Bar ReplacementWritten By: JacobINTRODUCTION

    TOOLS:Step 1 Back PlateStep 2Step 3Step 4 Whammy BarStep 5Step 6Step 7