Shade Sail Installation Process

Peninsula Shade Sails

www.peninsulashadesails.com.au

Step 1. - On site measure 

The first step in the installation of a shade sail is the initial consultation

with one of our shade design experts. This normally takes around one hour, once we understand the your shade needs we will advise on the best project design taking into consideration available post locations

and building fittings. Once complete our shade consultant will provide you

with a 2D diagram and a costing for the project.www.peninsulashadesails.com.au

Step 2. - Post and fitting installation 

After the project is approved we will prepare all the necessary posts and fittings when these are ready we will arrange a day that works for the client

for the installation of posts and fittings. The installation of posts and fittings for a standard shade sail configuration is a full day beginning in the morning with

the digging the post holes which are usually concreted into place at around midday. Finally the fittings are installed into the building and the sail is then measured. Our installation team are all in house staff who are highly trained

and understand the specifics requirements of building tension structures.www.peninsulashadesails.com.au

Step 3. - The crafting and hanging of the sail

The site sail measurements are run through our computer design software to equate for height variation in the sail to produce a 'cut sheet' which is where

our skilled sail craftsperson plots, cuts and sews the sail. When the sail is ready

we will call to arrange a time for our installers to come and hang and tension the sail this process normal only takes one hour.

www.peninsulashadesails.com.au

Thank You!

www.peninsulashadesails.com.au