RaspberryPi LED-Demo HowTo-Tutorial

" "This tutorial supports users during their first Hands-on Raspberry Pi LED DEMO experience

Required Materials

3x STP16NF06 MOSFET transistor get it from Amazon3x 1000 resistor get it from AmazonLED strip get it from AmazonDC power supply with 12V (depends on the LED strip)Raspberry PiPocket Code application with Raspberry support

Step-by-step Guide

Step 1: Intstall the server application on your Raspberry Pi

see here

Step 2: Connect your components

 

We recommend soldering a circuit board with all components to avoid annoying and confusing wires. In our case we only need four wires (Re, , and Ground) to connect the Raspberry Pi with our circuit board..d Green Blue

If you are using other pins on the Raspberry Pi than 40, 38 and 37 for , , , then you will have to adapt the port numbers of theRed Green Bluedemo program (in step 5).

   

Step 3: Install your Pocket Code Application with Raspberry Pi support

You can search for our application in the Google Play Store by searching for “pocket code”.

Step 4: Get our DEMO-Application for Pocket Code

 

unzip the program into your Pocket Code folder on your phone.

Step 5: configure Pocket Code and run the demo program

It is necessary to enable the Raspberry Pi feature in the settings and set the connection parameters (Host-Addres + Port) first!  The standardport is 10000

If you used other pins on the Raspberry Pi on step 2 than 40, 38 and 37 for , , , then it is necessary to adapt the port numbersRed Green Blueof the demo program

 

 

     

 

LED DEMO Pictures

 

& -> video1 video2