Itaca Jopix power upgradeIn this small article we will teach you to make the change of power needed to raise our Jopix Itaca 10W AM / FM and SSB 20W (approximately) Materials Needed: - Star Screwdriver - Pliers TIP: We suggest that you carry out this modification as well as the expansion of channels, which you can see in the list of contents for Ithaca Jopix We believe that the difficulty of this change is facili l so that anyone with the necessary materials might be carried out perfectly STEPS 1. Begin disassembling the tops of our radio station to do this we remove the 8 screws on the sides of the station 2. Once screws are removed we will remove the counter top to the speaker, after removal observe the part of the welds:

3. Expand the area and observed two marked resistance, which we cut for the extension:

4. Resistance will proceed to cut with pliers

5. We have preferred to cut only a "pin" and wrap the tape resistance, but everyone can make the change as it deems appropriate. Once this is done we can proceed to close our station with the appropriate screws and enjoy our Ithaca Jopix taking the maximum power

Itaca Jopix channel activation In this small article we will teach you to make the changes required extra channel activation in our Ithaca Jopix TIP: We suggest that you carry out this modification as well as the rising power of the station that you can see in the list of contents for Ithaca Jopix We believe that the difficulty of this change is easy so that anyone with the necessary materials might be carried out perfectly STEPS 1. Begin disassembling the tops of our radio station to do this we remove the 8 screws on the sides of the station

2. Once screws are removed we will remove the speaker cover carefully, paying attention to the speaker connector and then disconnect to work more comfortably

3. It's time to start our modification, so we must remove the plate that points in the image:

4. We removed our plate with a phillips screwdriver

5. Once we have proceeded to remove the screw we turn to our board and observe the following:

6. In the picture above we have identified a component, this component should be changed to the position just above yours. To make the change hold it with tweezers and remove it carefully.

If we are removing black piece in the picture above, you will be broke, so do not worry, this piece makes a bridge, so making a small weld between "stick" and "stick" efectuariía the same function. 7. Once the relocation of our part, will remain as in the following image:

9. It is time now for 3 seconds press the switch SW1 Once these changes we can close our station with the appropriate screws and connecting the speaker. Now we can only enjoy our station with high and low channels. To change bands we press the 2 key Some useful buttons: