hp vs cisco cli commands
DESCRIPTION
Comparison between cisco and HP networking devices commandsTRANSCRIPT
2/2/2015 HP vs Cisco CLI Commands | Evil TTL Network Solutions
http://evilttl.com/wiki/HPvsCiscoCLICommands 1/2
Evil TTL Network SolutionsEvil TTL > HP vs Cisco CLI Commands
View
Evil_TTL> show | s
HP vs Cisco CLI Commands
Category:HP > Routing and Switching
So here it comes when I actually had an opportunity to configure HP 5800 switches. I’d like to say thatnot a single issue arose. Mainly because there are tons of literature on the official HP website with verygood pictures and diagrams to every section of the configuration guides. Hence, there’s really not manynew things to write about here. Everything is written already. Anyway I’ll squeeze out some importantthings that could simplify life to a Cisco engineer who has layed his hands on an HP switch for the firsttime.
There’s a little table to start with.
HP Cisco Commentsystemview config terminalquit exitsave writereset savedconfig write erasereboot reload Initiated from User View onlydisplay current show rundisplay int brief sh ip int brdisplay logbuffer show logdisplay linkaggregation show etherchannel/portchanneldisplay this show current interface configsysname hostnameport linkmode bridge switchport
port linkmode route no switchport
port linktype access switchport mode accessport access vlan x switchport access vlan xport linktype trunk switchport mode trunkport trunk permit vlan x switchport trunk allowed vlan xport linkaggregation group x channelgroup xinterface BridgeAggregation x int portchannel xBy privilege15