Slide 1

Global Ozone Project Curriculum Lesson: Renewable Energy Rev 10A Brian Carpenter, Jessa Ellenburg and John Birks

Slide 2

Learning Objectives At the end of this lesson students should be able to: Identify Non-Renewable Energy Sources. Identify the top five Renewable Energy Sources. Identify Pros and Cons for each Renewable Energy Source.

Slide 3

Global Ozone Project Curriculum Part 1: Introduction to Energy Use

Slide 4

Energy Introduction Heat Engine: a device that can convert heat energy to mechanical energy. Fancy name for a car engine, a power plant, your refrigerator, air conditioner, etc. Efficiency of a heat engine is expressed in terms of the temperature difference between the hot side and the cold side. Efficiency = (T hot T cold )/T hot Cars are only about 20 to 30% efficient. Coal fired power plants are around 35% efficient.

Slide 5

Electricity Introduction Generating Electricity To get electricity, we convert mechanical energy to electrical energy Converting mechanical energy to electricity is done by electromagnetic induction discovered by Michael Faraday in 1831. Michael Faraday

Slide 6

Electricity Generating Electricity Spinning conductive wires inside a magnetic field causes electrons to move inside the wires, and moving electrons are electricity. We can use both renewable and nonrenewable energy sources (fossil fuels) to do this.

Slide 7

Energy Sources Major Renewable Sources Solar Hydropower Wind Biomass Geothermal Major Non-Renewable Sources Oil Coal Natural gas Nuclear Fuelwood

Slide 8

From Energy Sources to Electricity

Slide 9

US vs. Global Energy Use US Energy UseGlobal Energy Use

Slide 10

Energy Production by State

Slide 11

Global Ozone Project Curriculum Part 2: Renewable Energy Technologies

Slide 12

Renewables Major Renewable Energy Sources Hydropower Biomass Geothermal Wind Solar

Slide 13

Active Solar We utilize two types of Solar Energy: Active Solar & Passive Solar Active Solar: Technologies like Solar Panels (Photovoltaics) are used to convert solar energy into electrical energy.

Slide 14

Passive Solar - Heating and Cooling Passive Solar: Direct use of suns heat energy for home heating.

Slide 15

Passive Solar Water Heating Another use of passive solar to heat water for household use.

Slide 16

Solar Potential for the US

Slide 17

Costs of Solar Electricity (Active Solar) Costs of PV electricity: Industrial system (500 kilowatt system, about $2.5M). Sunny day: 15-20 cents/kWhr, 35-55 cents on a cloudy day. Home system (2 kilowatt system, about $18,000). Sunny day: 35 cents/kWhr, 80 cents on a cloudy day. Compare this with electricity from coal: Peak cost: 15 cents/kilowatt-hour. Off-peak cost: 10 cents/kilowatt-hour or less.

Slide 18

Pros and Cons of Active Solar (Solar Panels) Pros: Solar panels give off no pollution, the only pollution produced as a result of solar panels is the manufacturing of these devices in factories, transportation of the goods, and installation. Solar energy produces electricity very quietly. The ability to harness electricity in remote locations that are not linked to a national grid. The installation of solar panels in remote locations is usually much more cost effective than laying the required high voltage wires. Solar energy can be very efficient in a large area of the globe, and new technologies allow for a more efficient energy production on overcast/dull days. Space is not an issue because solar panels can be installed on top of many rooftops. Solar is cost-effective. Although the initial investment cost of solar cells may be high, once installed, they provide a free source of electricity, which will pay off over the coming years. Utilizing solar energy decreases dependence on fossil fuels. Cons: The major con of solar energy is the initial cost of solar cells. Currently, prices of highly efficient solar cells can be above $1000, and some households may need more than one. Solar energy is only able to generate electricity during daylight hours. The weather can affect the efficiency of solar cells. Pollution can affect a solar cells efficiency.

Slide 19

Pros and Cons of Passive Solar Heating/Cooling Pros: Renewable. No fuels required. Non-polluting. Carbon free except for production and transportation. Simple, low maintenance. Hot water provides some storage capacity. Operating costs are near-zero. Quiet. Few or no moving parts. Mature technology. Good return on investment. High efficiency. Can be combined with photovoltaics in highly efficient cogeneration schemes. Cons: Intermittent. Low energy density. Does not produce electricity. Supplemental energy source or storage required for long sunless stretches. Expensive compared to conventional water heaters. Construction/installation costs can be high. Hard to compete against very cheap natural gas. Some people find them visually unattractive. Manufacturing processes can create pollution. Installers not available everywhere. Generally not practical to store or sell excess heat. Produce low grade energy (heat vs. electricity). Dependent on home location and orientation.

Slide 20

Future of Solar Power Ways to improve: 1. Concentrators: these are mirrors that concentrate the suns energy to improve efficiency. 2. Hybrid Solar Systems: combine solar with other forms of energy production to make cheaper and more reliable. For example, solar-wind, and solar- hydro. 3. Consider Cost of Pollution: Cost of coal-based electricity is cheaper in part because pollution is not factored into the cost. Cost of pollution from solar (in manufacturing process) would be much less.

Slide 21

Hydropower Basics: Form of solar energy, as the sun drives water evaporation from the ocean and winds carry the moisture overland. Largest form of alternative energy used today. Industrialized countries have already tapped much of their potential. Non-industrialized countries have the most untapped potential.

Slide 22

Hydropower - Dams Dams Height of dam and mass of water determine useful energy. Efficiency is very good to excellent, generally 80 to 90% efficient in converting potential energy to electrical energy. Potential Energy = mass*gravity*height

Slide 23

Hydropower Generation Hydroelectric power production costs less than half of fossil fuel derived electricity (does not include construction costs).

Slide 24

Future of Hydropower Tidal Power: Propeller Systems Tidal Power: Wave Systems Tidal Power: Enclosures

Slide 25

Pros and Cons of Hydropower Pros: Very clean. Cheap. Flood control (primary reason for dams). Multiple crops per year possible. Cons: Potential is limited globally to about 5 to 10% of energy needs. Dependability is an issue; prolonged droughts can cut electrical production in half or more. Dams have drawbacks, including: Environmental impacts Loss of nutrient flow down river Loss of sediment flow down river Sedimentation behind the dam limits lifetime of the dam Flooding of scenic areas and archaeological sites Ecosystem below the dam is usually changed by having colder, nutrient poor water Aesthetics Loss of wild rivers

Slide 26

Wind Power Basics Use dates back thousands of years in the form of windmills, sailing ships, etc. Typical efficiency is about 30%. Maximum theoretical efficiency is thought to be about 60%.

Slide 27

Windmills

Slide 28

US Wind Power Potential Midwest has more than 90% of US potential

Slide 29

Wind Power Pros/Cons Pros Cost is very competitive, production costs are about 5 cents per kilowatt-hour (coal electricity is around 15 cents). This is down from 7 to 10 cents per kilowatt- hour in 1995 and 15 cents per kilowatt-hour in the 1980's. In this case subsidies helped to create a viable market. It is estimated that the costs could be lowered to 3-4 cents per kilowatt-hour as wind technology improves. Improvements in technology may also open less windy areas up for economically useful and viable wind power. Cons Reliability is a key issue, as the wind does not always blow. Requires a storage mechanism that compensates for reliability. Recently, aesthetics has become a significant issue. Killing of birds and bats from high blade tip speeds. Disruption of natural wind patterns.

Slide 30

Biomass Basics Energy from the sun, via photosynthesis in plants. This is the same energy we use as food. This is the same energy that made fossil fuels; fossil fuels are concentrated over time by the heat and pressure within the Earth. The oldest form of energy used by humans: wood fire, a form of biomass.

Slide 31

Biomass What is biomass? Any plant tissue can be used for energy, but the faster the plant grows, the more useful it is.

Slide 32

Biomass How does it work? How do we convert biomass energy to useful forms of energy? Direct burning Gasification Cofiring Fermentation

Slide 33

Future of Biomass GMO Energy Crops - like Poplar and Willow trees which have been genetically engineered and bred for rapid growth Algae - also grows rapidly Biodiesel - Canola and Sorghum, etc. Cellulosic Ethanol Developing ideas

Slide 34

Biomass Pros and Cons Pros: Truly a renewable fuel Widely available Generally low cost inputs Abundant supply Can be domestically produced for energy independence Low carbon, cleaner than fossil fuels Can convert waste into energy, helping to deal with waste Cons: Energy intensive to produce Land utilization can be considerable Requires water to grow Not totally clean when burned (NOx, soot, ash, CO, CO 2 ) May compete directly with food production (e.g. corn, soy) Some fuels are seasonal Energy required to transport Overall process can be expensive Some methane and CO 2 are emitted during production Not easily scalable

Slide 35

Geothermal Power Geothermal Electricity

Slide 36

Geothermal in the Home

Slide 37

Geothermal Potential in the US

Slide 38

Future of Geothermal Ocean Thermal Energy Conversion (OTEC): This is a special case of geothermal energy, as the source of the energy is the sun, warming the surface waters of the ocean. Uses the temperature difference between cooler deep and warmer shallow or surface ocean waters to run a heat engine and produce useful work, usually in the form of electricity. The cold water typically comes from about 1000 meters. Attractions of OTEC are: Steady source of energy (all day, all year). Potential large in warm areas (Florida, Hawaii) requiring air conditioning. Could use this energy to create hydrogen gas from seawater. Could be used to desalinize water. Mariculture (seafood farming)

Slide 39

Geothermal Pros and Cons Pros: Almost entirely emission free. The process can scrub out sulfur that might have otherwise been released. No fuel required (no mining or transportation). Not subject to the same fluctuations as solar or wind. Smallest land footprint of any major power source. Virtually limitless supply. Inherently simple and reliable. Can provide base load or peak power. Already cost competitive in some areas. Could be built underground. New technologies show promise to utilize lower temperatures. Cons: Prime sites are very location-specific. Prime sites are often far from population centers. Losses due to long distance transmission of electricity. Water usage. Sulfur dioxide and silica emissions. High construction costs. Drilling into heated rock is very difficult. Minimum temperature of 350F+ generally required.

Slide 40

Emerging Technologies There are many interesting emerging renewable technologies. A few examples are: Soccer Ball Charger Spray-on Solar Panels Green Gasoline What will you come up with??