PROJECT:

TITLE:

DRAWN BY: SOPREMA TECHNICAL SUPPORT, GGALLOWAY

NO.: DATE:REVISION:

DATE: 5.26.2017

SCALE: NTS

DRAWING NUMBER:

US.RSBS.08.03USAGE OF THIS DETAIL IS GOVERNED BY THE TERMS OF SERVICE FOR SOPREMA DETAILS.

PLEASE CONSULT THESE TERMS OF SERVICE PRIOR TO UTILIZING THIS DRAWING.

US CORPORATE ADDRESS310 QUADRAL DRIVE

WADSWORTH, OHIO 44281www.soprema.usTel:330.334.0066

W I L L I A M G R A N T G A L L O W A Y

DRAWING MUST BE VIEWED IN ADOBE READER TO ENABLE CUSTOM LAYERING

NOTES:1. SOPREMA DETAIL DRAWINGS: REFER TO SOPREMA AND OTHER RELATED PUBLISHED DOCUMENTATION, PRODUCT DATA SHEETS (PDS) AND SAFETY DATA SHEETS (SDS) FOR ADDITIONAL

INFORMATION. ALL DETAIL DRAWINGS AND RELATED INSTALLATION GUIDELINES ARE PROVIDED BY SOPREMA FOR THE SOLE PURPOSE OF ISSUING A SOPREMA WARRANTY. ACCORDINGLY, THEDETAIL DRAWINGS ARE NOT OFFERED, AND SHOULD NOT BE CONSIDERED, AS A SUBSTITUTE FOR PROFESSIONAL DESIGN SERVICES.

2. HOT WORK: THE CONTRACTOR IS RESPONSIBLE FOR DETERMINING APPROPRIATE CONDITIONS TO UTILIZE HEAT-WELDING EQUIPMENT. REFER TO THE NRCA CERTA RECOMMENDATIONS, LOCALCODES AND BUILDING OWNER'S REQUIREMENTS FOR HOT WORK OPERATIONS.

3. PRIMER: WHERE NOT SHOWN OR INDICATED ON DETAIL DRAWINGS, REFER TO MATERIAL PRODUCT DATA SHEETS FOR PRIMER APPLICATION REQUIREMENT.4. SOPRAJOINT CAN ACCOMMODATE A MAXIMUM GAP OF 2 INCHES AND A MAXIMUM 3/4 INCHES OF MOVEMENT.

2 PLY SBS MEMBRANE,INSULATED

LOW PROFILE EXPANSION JOINT

REMOVE/EMBED SURFACING AS REQUIRED

POLYESTER REINFORCED FLASHING CAP SHEETWITH GRANULE SURFACING

EXTEND FLASHING CAP SHEET A MINIMUM OF6" BEYOND SEPARATOR SHEET, HEAT WELD TOCAP SHEET ONLY

SOPRAJOINT VOILE 100, SEPARATOR SHEET LOOSE LAID

SOPRAJOINT, HEAT WELDED,REMOVE PAPER RELEASE FILM (NOT SHOWN) AFTER IT HAS COOLED

BASE SHEET/ANCHOR SHEET

BASE SHEET/ANCHOR SHEET

VAPOR RETARDER/AIR BARRIER

INSULATION

COVERBOARD

INSULATION

INSULATION

THERMAL BARRIER

DECKDECKDECKDECKDECKDECK

THERMAL BARRIER

DECKDECK

THERMAL BARRIER

GAP FILLED WITH COMPRESSIBLEINSULATION AS REQUIRED BY SPECIFIER

BASE PLY

CAP SHEET

INSTALL FASTENER PLATE A MINIMUM OF 1"FROM SEPARATOR AND SPACED A MAXIMUM

OF 12" APART ALONG EXPANSION JOINT

SOPRAJOINT LM BANDE, MINERAL WOOL LOOSE LAID

INSULATION