Mechatronics Research Labs
Automotive Control and Mechatronics Research Center
ICAT’08 İstanbulInternational Conference on Automotive Technologies
November 13 - 14th, 2008
FOHEV II - The Ford Otosan Hybrid Electric Research Prototype Vehicle
İsmail M.C. Uygan, Ahu E. Hartavi, Levent Güvenç, Tankut Acarman
Automotive Control and Mechatronics Research Center , Mechanical Engineering Department,
İstanbul Technical University, İstanbul, Turkey
Varlık Kılıç, İlker Özelgin, Murat Yıldırım
Ford Otosan, Research and Development Department, Kocaeli, Turkey
Volkan Sezer
The Scientific and Technological Research Council of Turkey, Marmara Research Center, Energy Institute, Gebze, Turkey
mekar.itu.edu.tr
autocom.itu.edu.tr2/28
Automotive Control and Mechatronics Research Center
ICAT 2008
mekar.itu.edu.tr
autocom.itu.edu.tr3/28
Overview
• Introductiono Hybrid Electric Vehicleo Market Trend of Hybrid Electric Vehicles
• Objective• History: FOHEV I• FOHEV-II Project Partners• Series-Parallel Hybrid Configuration• Components & Packaging• Real-time Control System• Control Strategy
o Start-up & Shut-down Preocedureo Maximizing Overall Efficiency Strategy for Power Split Controlo Hybrid Brake Algorithm
• Experimental Results• Conclusions
mekar.itu.edu.tr
autocom.itu.edu.tr4/28
What is Hybrid Electric Vehicle (HEV)?
• Internal Combustion Engine - The hybrid vehicle has an internal combustion engine much like the one found in most vehicles. However, the engine on a hybrid is smaller and uses advanced technologies to reduce emissions and increase efficiency
• Electric Motor - The electric motor on a hybrid car is very sophisticated. Advanced electronics allow it to act as a motor as well as a generator.
• Generator - The generator is similar to an electric motor, but it acts only to produce electrical power. It is used mostly on series hybrids.
• Controller: Manages the power flow and determines the mode of action.
• Batteries - The batteries in a hybrid car are the energy storage device for the electric motor. Unlike the fuel in the fuel tank, which can only power the internal combustion engine, the batteries on a hybrid car can put energy into the motor as well as draw energy from the motor.
Hybrid Electric Vehicle(HEV) uses both electrical motor and internal combustion engine.
HEV Main Components
mekar.itu.edu.tr
autocom.itu.edu.tr5/28
Why Hybrid Electric Vehicles?
Effects of Global Warming
Global Warming History and Future
The chief causes of global warming are burning fossil fuels, releasing them into the atmosphere, and the emission of carbon dioxide and other greenhouse gases.
Advances in Internal Combustion Engine (ICE) technology including advanced controls will not be enough to meet future emission reduction legislation. Hybrid Electric Vehicles (HEV) form an intermediate term solution for meeting these reduced emission level requirements.
mekar.itu.edu.tr
autocom.itu.edu.tr6/28
Hybrid Electric Vehicle Market
Worldwide Hybrid ElectricVehicle Saleshttp://www.marklines.com/en/numproduct/index.jsp#hybrid
mekar.itu.edu.tr
autocom.itu.edu.tr7/28
Objective
To design and build research prototypes of a hybrid electric light commercial vehicle based on the Ford Transit van, with internal combustion engine and electric motor(s) to reduce undesired emissions and to improve fuel economy while keeping the desired level of driving performance.
mekar.itu.edu.tr
autocom.itu.edu.tr8/28
History: FOHEV ITwo prototype research vehicles were built. FOHEV I, the first prototype, is a parallel HEV with 2+2 driving capability. ICE powers the front drive while the EM powers the rear drive. A rule based HEV control strategy is used. FOHEV I was built for maintaining high performance along with the advantages achieved through hybridization. All electric driving and regenerative braking are possible.
mekar.itu.edu.tr
autocom.itu.edu.tr9/28
History: FOHEV I HEV Controller
mekar.itu.edu.tr
autocom.itu.edu.tr10/28
History: FOHEV I Acceleration Performance
mekar.itu.edu.tr
autocom.itu.edu.tr11/28
History: FOHEV IIThe current research prototype vehicle, FOHEV II, is a series-parallel HEV with 2+2 driving capability. ICE and/or EM1 power the front drive while EM2 powers the rear drive. HEV control strategy used maximized overall efficiency in selecting the power flow path. All electric driving, ICE shut-down, stop and go, regenerative braking and series charging are possible.
EM1
EM2Serial EM
ICE
mekar.itu.edu.tr
autocom.itu.edu.tr12/28
* Overall project management and coordination* Supply of base vehicle* Design of modified vehicle* NVH studies* Determination of vehicle specs* Supplying the electrical machine, battery, control unit etc.* Supply/Manufacture of modified hardware* Integration of mechanical modifications* Performance / brake / fuel consumption and emission tests
* Concept study and simulations* Integration of electrical interface* Vehicle control and implementation* Development of regenerative braking algorithm and implementation* Control of electromechanical clutch* Data capture * Engineering support
* Selection of electric motors and battery* Electrical motors, battery, driver circuits* Concept study and simulations* Implementation of touch screen LCD* Engineering support
* Concept study and simulations* Design and implementation of electromechanical clutch system* Road tests* Engineering support
Project Partners
FORD OTOSAN
ITU-MEKAR
ITU-OTAMTUBITAK
MAM
FOHEV-II Project Partners
mekar.itu.edu.tr
autocom.itu.edu.tr13/28
System Architecture
13
Modes of Operation Pure ICE Mode Pure EM Mode Hybrid Mode Cruise Charge Assist Serial Charge
Hybrid Braking
Schematic of FOHEV-II Prototype Components and Interactions
mekar.itu.edu.tr
autocom.itu.edu.tr14/28
Electric Motor Assembly
14
Electric Motor Assembly
Electrical Machines Rated Power 25 kW Brushless DC Machines
mekar.itu.edu.tr
autocom.itu.edu.tr15/28
Li-Ion Battery Pack
15
Energy Storage Unit
The battery pack provides the maximum power required by the traction/braking motors at the same time.
Li-Ion 324 VMax Power 50kWCapacity 14.5 kWh
Li-Ion Battery Pack
mekar.itu.edu.tr
autocom.itu.edu.tr16/28
Transmission
16
The new transmission enables:
Driving the front axle by ICE and/or EM1.
The use of regenerative braking and electric traction independent of the selected gear.
To shift the operating point of the diesel engine by loading or assisting it with EM1.
New Transmission
mekar.itu.edu.tr
autocom.itu.edu.tr17/28
Clutch Control System
17
The hydraulic clutch control system was modified to add the capability of keeping the clutch disengaged independent of the driver.
Configuration of modified electromechanical clutch
Conventional Mode: According to the driver’s request the power flow is cut by depressing the clutch pedal.
Hybrid Mode: The clutch is controlled according to the hybrid control algorithm.
mekar.itu.edu.tr
autocom.itu.edu.tr18/28
Retrofitted APM
18
To shift the operating point of the ICE to a more efficient region necessitates the modification of the Accelerator Pedal Module in a way that the hybrid controller can interfere in the gas signal sent from the APM to the ICE-ECU.
Accelerator pedal module & interface circuit
mekar.itu.edu.tr
autocom.itu.edu.tr19/28
Hybrid Control System
19
Hybrid powertrain control system schematic
mekar.itu.edu.tr
autocom.itu.edu.tr20/28
Start Up - Shut Down Procedure
Start up procedure:Battery supply is provided with the engine start upBattery KL-15 is shorted EMs are shorted
Shutdown procedure: Starts with the after-run state of engine It is in the reverse order of the start-up procedure.
Hybrid powertrain control module logical schematic
mekar.itu.edu.tr
autocom.itu.edu.tr21/28
21
Maximizing Overall Efficiency Strategy receives the gas pedal position and distributes the corresponding torque demand among the available paths to achieve the maximum overall efficiency.
MOES Strategy
Velocity Controller
Vdes
vehV
MOES
CONTROLLER
,
Battery
brk
Vveh
SOC
Vbat
EM1
EM2
EM3
ICE
Regenerative Braking
Controller
thr
ICET
3EMT
2EMT
1EMT
3_refEMT
_refICET
2_refEMT
1_refEMT
1_refEMT
2_refEMT
vehV
Autogear
ICE
vehV
clt
clt
gn
gn
Parameter Update
KchKdch
Perpch
Ibat
Simulation model of the hybrid powertrain with MOES controller
mekar.itu.edu.tr
autocom.itu.edu.tr22/28
Hybrid Brake System & Strategy
22
Hybrid brake system integrates regenerative braking into conventional hydraulic brake module to assist the brake torque production while recapturing brake energy.
Hybrid brake strategy logical schematic
mekar.itu.edu.tr
autocom.itu.edu.tr23/28
Videos of FOHEV II
mekar.itu.edu.tr
autocom.itu.edu.tr24/28
Parallel Charge Regenerative Braking Assist
Experimental Results
mekar.itu.edu.tr
autocom.itu.edu.tr25/28
The modification process of a front wheel drive Ford Transit vehicle into a four wheel drive series-parallel hybrid electric vehicle having the working modes listed below was presented.o Pure ICE o Pure EMo Hybrid tractiono Engine start/stopo Hybrid braking
The mechanical modifications and packaging of the electrical systems, the electrical modifications such as signal interfacing studies, regenerative braking capability and the hybrid electric control algorithm were also presented.
An Optimal Power Management Strategy for a Hybrid Electric Vehicle (MOES), was developed, simulated and implemented in the FOHEV-II prototype. Other novel power management strategies are also being developed.
An Electric Power Assisted Brake algorithm was developed and implemented to the research prototype by considering brake force distribution, torque capacity of EMs, state of charge of battery and operating conditions of the vehicle.
Conclusions
mekar.itu.edu.tr
autocom.itu.edu.tr26/28
FC@ECE
Diesel [l/100km] 10.88
Hybrid [l/100km] 7.39
Reduction [%] 32.1
FC@NEDC
Diesel [l/100km] 8.82
Hybrid [l/100km] 6.53
Reduction [%] 25.9
Table 1. Fuel Consumption Estimations
Simulations and preliminary tests showed that the fuel consumption estimations presented in table below, can be achieved with this new type of hybrid powertrain.
Conclusions
The hybrid electric Ford Transit was publicized with a press release with an accompanying test drive. Work on performance evaluation and enhancement is currently in progress.
mekar.itu.edu.tr
autocom.itu.edu.tr27/28
Acknowledgments
27
The authors would like to acknowledge
Ford Otosan R&D Department for support through the FOHEV projects
&the European Union Framework Programme 6 through project INCO-16426 for helping İTÜ-Mekar improve in its research thrust area of hybrid electric vehicle modeling, control and hardware-in-the-loop simulation
Special thanks also go to the Project Partners for their technical support in making this project a success.
mekar.itu.edu.tr
autocom.itu.edu.tr28/28
Questions ?
28