ASSEMBLY INSTRUCTIONS
Thank your for selecting one of our pieces to become part of your home. We are here to guide you during the assembly. If you need help or need extra hardware simply contact our support team at [email protected] or call us at 1(800) 652-6344. Mon-Fri 9:00am - 5:00pm EST. Talenti Casa is Registered Trademark distributed by Casabianca Home.
• Assemble this product on a soft surface to prevent scratching the product.• Hardware can be found inside drawers or underneath the product.• Do not discard any of the packaging until you have successfully assembled the product.
Unpack Box #4; the base of the table, and place it in the area where you would like to set the table.
ASSEMBLY TIPS
STEP 1
Unpack Box #3; the frame of the table.When unpacking it, do NOT remove the four (4) plastic tie straps.
STEP 2
Care Instructions Case goods (C): Dust with a soft, dry cloth. All spills should be cleaned up immediately. Use glass cleaners on glass only. DO NOT use any abrasive cleaning supplies.
CARE INSTRUCTIONS
1
WARNING: DO NOT LEAVE
CHILDREN UNATTENDED
WHILE INSTALLING OR
OPERATING THE MOTORIZED
TABLE. THIS IS NOT A TOY
AND SHOULD NOT BE
MANAGED BY CHILDREN.
TABLE COULD CLOSE
UNEXPECTEDLY.
PLEASE USE CAUTION.
h e y !i m n o t y o u r
t y p i c a l t a b l eI a m m o t o r i z e d
Insert screw #M8 x 12mm and tighten it with the Hex key provided.
Place the frame upside down on top of a blanket or foam.
STEP 5
STEP 3
Then place the base on top and align the four (4) holes of the base with the four (4) holes on the frame on each end..
STEP 4
Adjust the bottom levelers if the table is not leveled.(This step is only available with certain bases).
STEP 7
Open Box #1; Main center top. Turn it upside down and screw the 4 level wheels all the way to the end.
STEP 8
Flip the table
STEP 6
2
Locate the key hole under the table, insert the safety key and turn on power. Instruct the user this key is for CHILD SAFETY.
Place the center glass on top of the rails and make sure the pins go inside the four (4) cylinders on the frame. .
STEP 11
STEP 9
Remove the four (4) plastic tie raps and make sure the extension bars are down..
STEP 10
Unpack Box #2; the side extensions. Place screw M8 x 25mm with no Head on each extension and tighten.
STEP 13
Place the adjusting wheel on the screw (This adjusting wheel will dictate the height of the glass and later will be used to align with the glass top)
STEP 14
Extend the table extensions by pressing and holding the buttons on the table.
STEP 12
3
Tighten the extensions with the M8 Cap screw.
Tighten center top with small Hex key provided
Place each extension carefully on top of the metal frame, align the sides with the center top.
STEP 16 STEP 17
STEP 15
1. Locate the receiver and battery pack box from under the table.
2.Make sure power is on. Then unscrew only highlighted screws, this
will release the box out.
4
TROUBLESHOOT MANUAL
1 . 2.