i732-411 www.powercommander.com 2007-2008 Ducati Hypermotard - PCIII USB - 1
2007-2008 Ducati HypermotardInstallation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter1 Wire Tap2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Alcohol Swab4 Zip ties
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port
4. Continue routing the PCIII harnessalong left hand frame rail.Route the ORANGE colored wires tothe right side of the bike following theframe cross member (Fig. B).
5. Unplug the stock wiring harness fromthe rear injector (Fig. C).This injector is located on the lefthand side of the bike.
Fig
. A
Fig
. B
Fig
. C
i732-411 www.powercommander.com 2007-2008 Ducati Hypermotard - PCIII USB - 2
Unplug
PCIII harness
1. Remove the seat.2. Remove the fuel side panels.3 Lay the PCIII near the battery and
route the harness down the left handside of the bike (Fig. A).
PCIII harness
6 Plug the YELLOW colored wiresfrom the PCIII in-line of the rearinjector and stock wiring harness(Fig. D).
7 Unplug the stock wiring harness fromthe front injector (Fig. E).This injector is located on the righthand side of the bike.
8 Plug the ORANGE colored wiresfrom the PCIII in-line of the frontinjector and stock wiring harness(Fig. F).
Fig
. D
Fig
. E
Fig
F
i732-411 www.powercommander.com 2007-2008 Ducati Hypermotard - PCIII USB - 3
Unplug
PCIII connector
Stock connector
Stock connector
PCIII connectors
9 Locate the stock Throttle PositionSensor. This sensor is located on theleft side of the throttle bodies.
10 Cut a 1” slit in the sheathing for theTPS harness. This allows access tothe wires.
11 Using the supplied wire tap crimp theORANGE wire (Fig. G).
12 Connect the GREY wire from thePCIII harness to the wire tap (Fig. G).It is recommended to use dielectricgrease on these connections.
13 Attach the ground wire from the PCIIIharness to the negative terminal of thebattery (Fig. H).
14 Install the PCIII to the side of the bat-tery using the supplied velcro (Fig. H)Make sure to clean both surfaces withthe alcohol swab before attaching.
15 Reinstall side panels and seat.
Fig
. G
Fig
. H
i732-411 www.powercommander.com 2007-2008 Ducati Hypermotard - PCIII USB - 4
Grey wirefrom PCIII
Wire tap
Ground wire
PCIII