compound angle compensation.pdf
TRANSCRIPT
-
COMPOUND ANGLE COMPENSATION
When setting compound angles, it is necessary to compensate for the first angle set in order to correctlyset the second angle. To obtain this compensation, refer to the following drawings and procedures.
where:
Angle A = First desired angle
Angle B = Second desired angle
Angle C = True angle setting required to get angle B
VIEW OF PART
Set the first of the desired angles (Angle A) on the top section of your compound sine plate.1.Calculate the tangent of the True Angle (Angle C) using the formula:
Tan (True Angle C) =Tan (Angle B) X Cos (Angle A)
2.
Lookup the True Angle (Angle C) in a table of tangents (or use the inverse tangent function on yourcalculator).
3.
Set the lower section of your compound sine plate, using the proper sine table and the True Angle(Angle C).
4.
Results: The compound sine plate is now set to obtain the desired angles (Angles A & B) in theirrespective planes.
5.
Automation and Metrology 130 Liberty Street Painesville, Ohio 44077Phone: (440) 354 6436 Fax: (440) 639 9983
E-mail: [email protected]
Suburban Tool - COMPOUND ANGLE COMPENSATION http://www.auto-met.com/subtool/stcat/st_137.html
1 de 2 17/08/2014 23:56
-
Suburban Tool - COMPOUND ANGLE COMPENSATION http://www.auto-met.com/subtool/stcat/st_137.html
2 de 2 17/08/2014 23:56