swh standard rail swh ecolite railesolarwarehouse.com/wp-content/uploads/2017/10/622-… ·  ·...

9628 Valley Blvd. Rosemead, CA 91770 | Phone 626-579-3288 | info@esolarwarehouse.com

SWH Racking System Data Sheet Version 12.10.v2

Splice bar material: 6005-T5 extruded aluminum alloyFinish: Clear or black anodizedSelf-tapping screw material: 304 stainless steelSplice bar weight: 0.32 lbs A thermal break is required every 40 feet of continously connected rail. For additional concerns on thermal breaks in your specific project, please consult a licensed structural engineer.Expansion joints prevent buckling of rails due to thermal expansion. Splice bars may be used for thermal expansion joints. To create a thermal expansion joint, slide the splice bar between the rail segments. Secure the splice bar with two screws on one side only. Footings (such as L-brackets or standoffs) should be secured normally on both sides of the splice. No PV module or mounting hardware component should straddle the expan-sion joint.

•••••

•

SWH 6” F Splice Barfor Standard Rail & Ecolite Rails

MFG-PN: MR-SW-SB-03M, MR-SW-SB-03B

SWH Ecolite Rail

6” F Splice bar

Self-tapping screws

SWH Standard Rail

6 inches