ir object detection living with the lab ir light from led ir light reflected off object ir led ir...
Post on 20-Dec-2015
236 Views
Preview:
TRANSCRIPT
IR Object Detection
living with the lab
IR light from LED
IR light reflected off object
IR LED
IR receiver
Infrared (IR) light leaving an LED reflects off an object. The reflected light travelsback to an IR receiver. The IR receiver “detects” the presence of the object. The object does not need to move to be detected.
living with the lab
2
Panasonic PNA4602Msupply voltage: 4.8V – 5.2Vcurrent: 3mA
This sensor detects infrared (IR) light. However, to avoid detecting the IR component of regular sunlight or light from other stray IR sources, the sensor only looks for light coming in at 38 kHz.
IR LED (not your usual LED)outputs 940 nm wavelength light
We write an Arduino sketch to make this LED flash 38,000 times per second so it can be detected by the PNA4602M.
The Parts
living with the lab
3
IR Light IR detector is most sensitive around 950 nm or 0.95(10)-6 m
wikipedia.org
Panasonic documentation for PNA4602M
living with the lab
4
Install an LED Shield
It is important to install the LED in an enclosure to properly direct the IR light. Your kit includes the black pieces shown. Insert the legs of the LED through the holes in the longer black cylinder, and then install the smaller top piece over the exposed end of the LED.
If you don’t have a shield, a piece of paper can be rolled up and taped around the LED.
Your LED will look like this after shielding.
living with the lab
5
220Ω
from digital outputpin on Arduino
LED Circuit IR Receiver Circuit
Be sure to aim your LED and IR detector so that they have a clear view (nothing in the way)
5V
220Ω
to digital inputpin on Arduino
living with the lab
6
Arduino Sketchvoid setup() Serial.begin(9600); // allows output to display pinMode(2, OUTPUT); // define digital pin 2 as an output (output to LED) pinMode(3, INPUT); // define digital pin 3 as an input (input from sensor)
void loop() tone(2,38000); // output a LOW HIGH LOW sequence at 38,000 Hz int IR_status= digitalRead(3); // acquire the status of the IR sensor Serial.println(IR_status); // display the status of the IR sensor delay(100); // wait 100ms between sensor queries
nothing is detected by IR sensor
something is detected by IR sensor
top related