baby frock

Post on 29-Aug-2014

12.071 Views

Category:

Design

0 Downloads

Preview:

Click to see full reader

DESCRIPTION

THIS PPT CONTAINS ALL THE NECESSARY DETAILS NEEDED TO CONSTRUCT A BABA SUIT.

TRANSCRIPT

BABY FROCK

INTRODUCTION

This is garment worn by girls of age groups 3 and more. It is also called A-line frock. It is worn in summer.

FLAT PATTERN

MEASUREMENTS REQUIREDChest=20”Back width=9”Back waist length=9”Frock length=18”Short sleeve length=4.5”Lower arm circumference=8”Full sleeve length=13”Wrist circumference=5.5”Hip=21”Waist to hip=4”

FABRIC REQUIREMENTFabric width=36”

A-Line frock:Frock length+5”=23”

A-Line frock with sleeve and collar:Frock length+sleeve length+6”=28.5”Frock with plain bodice, gathered skirt, peterpan collar and puff sleeve:Twice frock length+sleeve length+9”=49.5”

FABRIC TYPE•Poplin•Rubea•Lone•Cambric•Satin•Terricott•Net

DRAFTING PROCEDURE

BASIC BODICE

•Construct rectangle ABCD with the following measurements•AB=1/4(chest + 5” ease allowance) =6.25”•AD=BC=back waist length+1/2”.•Mark AG=1/2 back width=4.5”•AF=1/12 Chest•AH=1”•AJ=1/12 chest+1/4”= AF+1/4”•GK=1”•Connect HF with a bold line as shown. This is the back neck line.•Connect JF with dotted line as shown. This is the front neck line.•Connect FK with a straight line. This is the shoulder seam.•Mark BL=1/4 chest=5”•Draws GO parallel to and equal to BL. •Mark KX=1/3 KO and XY=1/2”.•Connect KXL as shown with a bold line. This is the back armscye line.•Mark CM=1/2”.connect LM. This is the side seam.

BABY FROCK•This is adopted from the bodice pattern as below.•Trace the basic front bodice pattern on a large sheet of •paper and label it as JFKLMD.•Extend the center front line JD till T taking DT=skirt length.•Draw TT1=L1L+1 to 1.5” depending on the flare required.•Connect LT1 with a straight line.•Mark LU=L1T.•Connect TU as shown for hem line.•If you desire to have shaping near the waistline, connect •MU and take LMU as the side seam.

SEAM ALLOWANCE:

•Leave ¼” for neckline and collar•Leave 3” for skirt hem•Leave 1” for sleeve hem.•Leave ½” for all other seams

CONSTRUCTION PROCEDURE

•Join shoulder seams•Finish placket opening at the back•Finish the neckline with shaped facing•Finish the side seams

•Finish bottom hem

LAY OUT

VARIATIONS

THANK YOU

top related