ad-1 universal auto diagnsotic scanner

AD-1 Auto Scanner AD-1 Auto Scanner

Configuration Software Diagnose FAQFeatures

Features Features

Home

1.Universal

2.Wireless

3.Remote diagnosing

Features Features

4.Platform: Operates on either XP or Vista operating systems.5. Interface: USB "plug-and-play" technology and high baud transceiver for faster data transfer.6. Report: Results can be saved and printed for later reference.7. Upgrading: Software can be upgraded anywhere via internet. 8. Hardware: Anti-shock rubber guards for stronger, more durable usage.…

Home

Configuration Configuration

AD-1 Multiplexer Transceiver

Main Cable USB Line

Battery Clips Ignition Lighter Cable Adaptor Storage Case

Home

Software Download Software Download

Download Page: http://www.autoobd.net/english/download/download.asp

AD-1 Client Software

AD-1 USB Driver

Home

Software Setup Software Setup

Install the AD-1 client software.

Home

Main Interface Main Interface

If use the software at first time, please click the SETTING buttonand set COM port..

Home

Check COM Port Check COM Port

Check the CP210XUSB COM port fromDevice Manager.

And then set the same com port in the AD-1 software as above.

Home

Wireless Connection Wireless Connection

Wireless communication can reach from 20 to 50 meters.

Home

Connection with wire Connection with wire

You may operate the device based on any laptop or desktop. The diagnostic connectors would be different due to the vary vehicle.

Home

Diagnose Diagnose

Select the model of the car you want to diagnose ( JAPAN – TOYOTA )

Home

Select Connector type [ OBDII-16A ]

Diagnose Diagnose

Home

Diagnose Diagnose

Select the system ( ENGINE )

Home

Diagnose Diagnose

DIAGNOSE ITEM: Diagnostic Trouble Codes Information;Data Stream List;Active Test.

Home

Diagnose Diagnose

Test result: No fault code

Home

Diagnose Diagnose

Data stream list(Simulation Testing result )

Home

Diagnose Diagnose

Read ECU Memory(Audi/VW Testing result )

Home

FAQ FAQ

What can we do if the system still in wait state?

Home

FAQ FAQ

Click RESET back to initial state.

Home

FAQ FAQ

It is due to the software com port setting failed. Go back to thesoftware main page, click button “ SETTING”, and then selectthe correct com port. ( You may refer to the USB driver installation in this manual). If still same problem, re-plug the USB line and try it again.

Home