1

MUSTHAVE

SHOULD

HAVE

COULDHAVE

Module # 140

Practical Class Exercise’s, 2nd session

• Objectives:• Know how to:

– Setup a Flowmeter

– add Channel based on a Flowmeter

– Add and configure a Flowmeter based MP

– Add and configure LIW MP

– Add and configure Dump to Empty MP

– Use the above Material Paths to do Feeds

– Reference: Qi Technical manual.doc• Ch 3 – Flowmeter program block• Ch 4 – Flowmeter• Ch 4 – Assign Channels• Ch 4 – Configure Material Paths

3

Class Exercise #1 – Setup a Flowmeter

• Via the Flowmeter Button Configure Flowmeter (K) – Verify Flowmeter is functioning

• How ? :Switch to the Flowmeter Channel and manually add water, check to see that the Qi display is counting.

• Via the PAC Button Add a Flowmeter based Channel, use Channel 3

– Reference: Qi Technical manual.doc • Ch 3 – Flowmeter program block• Ch 4 – Flowmeter

– Refer to next slides after your own attempt.

4

A Configured Flow meter

• A correctly configured Flow meter example

5

Example of Flowmeter based Channel

• Note: Some parameters are Instrument capacity dependent

6

Class Exercise #2

• Add MP2, GIW & SPILL only– PAC >> Material Paths

– Enter required MP number

– Configure all Parameters• TIP: Save this page as : “Defaults” then this page can be loaded and edited

• Do some Feeds using this Material Path (refer Module 090)– Check that Feeds are error free with a green screen

– Example follows on next slide. Try on Own first

7

A Configured MP2

8

Class Exercise #3

• Add MP3, LIW & Dump to Empty– PAC >> Material Paths

– Enter required MP number

– Configure all Parameters• TIP: load previously saved “Defaults” and edit

• Do some Feeds using this Material Path (refer Module 090)– Check that Feeds are error free with a green screen

– Example follows on next slide. Try on Own first

9

A Configured MP3

10

Class Exercise #4

• Add MP4, LIW & K1– PAC >> Material Paths

– Enter required MP number

– Configure all Parameters• TIP: load previously saved “Defaults” and edit

• Do some Feeds using this Material Path (refer Module 090)– Check that Feeds are error free with a green screen

– Example follows on next slide. Try on Own first

11

A Configured MP4

12

Class Exercise #5

• Add MP7, GIW use (Flowmeter as the channel)– PAC >> Material Paths

– Enter required MP number

– Configure all Parameters• TIP: load previously saved “Defaults” and edit

• Do some Feeds using this Material Path (refer Module 090)– Check that Feeds are error free with a green screen

– Example follows on next slide. Try on Own first

13

A Configured MP7

Review Questions

• Can you add a Material Path while still in “Run Mode” ?• Can you edit a Material Path while still in “Run Mode” ?• What are the Four Material Path “Feeder Types” ?

• Bonus Questions• What is the meaning of the “Assembly Slot” number that is

found on the Channel Setup Page? ?• Can it be edited