yamaha fzs600 s u p p l e m e n t a r y m a n u a l...yamaha fzs600 1998-2001 remove the main seat....
TRANSCRIPT
Yamaha FZS6001998-2001
Remove the main seat.
www.healtech-electronics.com
S U P P L E M E N T A R Y M A N U A Lfor QSE-1 + QSH-P2T
PAGE 1/3
Lift up or remove the fuel tank.
Take off the Red/Black terminal from one coil.
Connect the QSH Green terminal to this coil terminal.
Yamaha FZS6001998-2001
www.healtech-electronics.com PAGE 2/3
Connect the Red/Black terminal to the QSH Red wire
terminal and secure with tape.
Splice the QSH White wire to the Gray wire of the coil by
using the suppliedred wire tap connector.(refer to the QSH-P2T instructions)
Take off the Red/Black terminal from the 2nd coil.
Connect the QSH Green terminal to this coil terminal.
Isolate the unused Black/White terminal with tape.
Yamaha FZS6001998-2001
www.healtech-electronics.com PAGE 3/3
Typical position for theQuickShifter easy.
Mount the QSE sensor.(Replace the bolt with the one supplied.
Place the conical washers at the two sides ofthe sensor like this: (0).
Tighten the bolt inthis position by about 5-6 Nm.
If you do not havea torque wrench, tighten the bolt until the
shift arm is tight on the gearbox shaft.
For different mounting options,refer to the sensor install guide.)
Connect QSH black wire terminal to chassis ground.