y mosaic palette 2 (pro) bottom up stand remix · mmontminy mosaic palette 2 (pro) bottom up stand...
TRANSCRIPT
mmontminy
Mosaic Palette 2(Pro) Bottom UpStand remix
VIEW IN BROWSER
updated 21. 8. 2019 | published 21. 8. 2019
PRUSAPRINTERS
Summary
I tried a few different Palette upside-down solutions to go on top of my lackenclosure, and found CarstenD's (https://www.thingiverse.com/thing:3458138) to work the best. The angle it was tilted at combined with theheight placed it at an awkward angled for the filament path from myRepBox into the Palette though.
After lots of slicing dicing and twisting in Fusion, I was able to remix it intosomething that suits my needs better. This one is a little lower in overallheight, and stands a little more upright.
3D M
ODEL
ONLY
Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES
23.7 KBupdated 21. 8. 2019
116.0 KBupdated 21. 8. 2019
3D Printers > Other Accessories
palette2 mosaic
Depending on your printer and filament, you can likely print this withoutsupports. There are no bridges, but there is a good amount of overhangperimeter which are more severe than the original design. They were alittle droopy, but perfectly functional. Your mileage may vary.
You can try to reduce the infill, but too little and there won't be enoughsupport for upper layers at the bottom of the cradle where the Palette sits.My first attempt with 5% infill failed. 20% works fine.
Find source .stl files on Thingiverse.com
The Author has not uploaded any G-codes.Try to search in User G-codes section or generate and upload yourown.
palette_2_mc_lock.stl
palette_2_mc_stand_1.stl
License
This work is licensed under a Creative Commons (4.0 International License)
Attribution-NonCommercial
✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition