DO NOT DUPLICATE CONFIDENTIAL INFORMATION AND PROTECTED UNDER U.S. COPYRIGHT LAWS 2010 FACTORY FIVE RACING, INC. Server\Company\Instructions

Part Number: 12244 Revision: D Effective Date: 08/23/10 By: J. INGERSLEV Document Type (indicate): ° Bill of Material ° Drawing (may be attached) ° Specification • Assembly Instructions ° Operating Procedure ° Other

WIND WINGS Installation Instructions

I. Parts Included in Kit:

12049 WIND WING, W/MOUNTING HARDWARE, PAIR EA 1.00

12244 WIND WING INSTRUCTIONS EA 1.00

13608 WIND WING PLASTIC, DRIVER EA 2.00

13609 WIND WING PLASTIC, PASSENGER EA 2.00

13610 WIND WING BRACKETS EA 1.00

13611 WIND WING FASTENERS EA 1.00

II. Tools Required: Philips head screwdriver Flathead Screwdriver 2.5mm Hex key

8mm wrench Loctite™ III. Installation Instructions 1. Peel Backing paper off Wind Wings. 2. Assemble the mounting brackets as shown in the picture below. Insert the long screw from the

bottom side for the driver side.

Passenger side Wind Wing mounting bracket.

3. Mount the brackets to the wind wing using the small screws and flat washers. Use a small amount of

loctite™ on these screws because they can work loose over time from positioning of the wind wings. (Be careful not to get any Loctite™ on the clear wing, it will form a haze that will not come off).

4. Attach the wind wings to the windshield sidebars using a 3/32” hex key. The “Factory Five Racing

will be readable from the inside of the car. Attach the Wind Wing so that it will not hit the body or door when moved. This will be approximately just below the botom and third sidebar screws.

Wind Wing bracket mounted to the windshield sidebar.

Wind Wing mounted to the windshield.