vinyl tri-fold cover installation instructions · 2019. 3. 6. · vinyl tri-fold cover installation...
TRANSCRIPT
Vinyl Tri-Fold CoverInstallation Instructions
How To Adjust Clamps The clamps might need adjusted. To adjust, turn handle on clamp clockwise to tighten or counter clockwise to loosen.
Lip of clamp
D1
D2
D3
1
2
5
6
7
2&7. To clamp cover down, put lip of clamp under side bed rail and push handle down. (See D1, D2, D3)
3
2. Secure front clamps. Trucks with Utility Track see Step 9.
3. Undo both clips so cover can be unfolded.
4. Unfold first section.
6. Cover is laying down flat.7. Secure rear clamps for a tight fit.
8. Vehicles With Utility Track All Toyota Tacoma or Tundra Pickups. 2007 GMC/Chevy Pickups 2008 Ford Pickups 2008 Nissan Pickups 2008 Dodge Pickups Use aluminum block to attach cover by sliding into place and locking clamping on to blocks. (See Back For Details)
Page 1
Tonneau Cover is locked
into positionwhen handle is
down on both sides
Use orange clip to store clamp when cover is folded.
9-13-12
4
1. Place the cover on front of truck bed.
200 Universal Dr. Owosso, MI 48867 989-725-8354 Fax: 989-725-8409 1-800-433-3604
Patent No’s. 7,823,957 /8,146,982 /8,256,824
5. Unfold second section.
Place dust seal between cab and truck bed.
Page 2
8A
GM Pickups withUtility Track
BC
A. Slide aluminum blocks into track, position and tighten set-screw.B. Secure front clamp on to aluminum block.C. Attach rear clamps
A
Nissan Pickups withUtility Track
BC
8
A
Toyota Pickups withUtility Track
BCD
8A
Dodge Pickups withUtility Track
BC
8
Useful Information.
A. Loosen rear 2 bolt’s on utility track and slide aluminum blocks into track.B. Re-tighten rear 2 bolt’s. Then position and tighten blocks with set-screw.C. Secure front clamp.D. Attach rear clamps.
9A. If there is a gap from the corner to the edge of the wing tailgate piece when the cover is fastened. (1) You can put an extra foam corner piece on the back existing corner pieces. (2) Take the roll of foam and measure from the edge of the tailgate piece to the edge of the corner piece on both sides, cut and stick to existing foam.
(1)
(2)
(A)
B. Or, Replace the Wing Style Tailgate Piece with a Flatter Style Tailgate Piece.
A
Ford Pickups withUtility Track
BC
8
A. Slide aluminum blocks into track, position and tighten set-screw.B. Secure front clamp on to aluminum block.C. Attach rear clamps
A. Slide aluminum blocks into track, position and tighten set-screw.B. Secure front clamp on to aluminum block.C. Attach rear clamps
A. Slide aluminum blocks into track, position and tighten set-screw.B. Secure front clamp on to aluminum block.C. Attach rear clamps
9-13-12