using spectrum sweeps
TRANSCRIPT
Spooky2 Using Spectrum Sweeps
Our Users & Team
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
Have you been interested in trying the Spooky Spectrum Sweep or
Converge Sweep, but felt that it may be too difficult, and so you st
ayed away?The following shows how to setup a Spectrum Sweep
that targets 76000 Hz to 880000 Hz, attacking the pathogens from
both ends.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
First let's create the custom Spectrum Converge Sweep.
In Spooky2, go to the File menu, and select Create Spectrum
Sweep.
A new window will pop up that looks like the following. Fill it out
using the information shown in the image below and save.
After you have saved the information, go to the Database menu,
and click on Refresh Database.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
Then, we will need to setup Spooky2 to run the newly created Spo
oky HC Converge Sweep.
Use the image below to setup the program options. Once you are
done, you can save this as a preset by giving it a name in the Prog
ram Preset field and clicking the large + to the right. This will make
it easy to recall the program for future use.
To be able to edit and set the Out 2 Controls, you must select Follo
w Out 1 first.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
Of note, the repeat program setting in the following screen shot
is set to 0. When you go to run this, you may want to choose h
ow many repetitions to use. The entire sweep takes 3,333 seco
nds to complete (interesting number synchronicity) or 55 minut
es, 33 seconds. At a minimum I would suggest running for at le
ast a full day.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
If you do not have a Spooky Boost, you can plug two Spooky Rem
otes into each output of the generator.
If you do not have two Spooky Remotes, you can still run this with
a single Spooky Remote installed on output 1, you will just loose th
e benefit of the reverse sweep.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
It is important to note that due to the power requirements of a Spe
ctrum Sweep, this is currently only viable via remote or plasma ap
plications. If plasma is used, select Square waves, 5 volts Amplitu
de and 0% offset.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:[email protected] [email protected]
Thank you!