user guideuser guide - ?· user guideuser guide ... reverse current protection ... omicron lite &...

Download User GuideUser Guide - ?· User GuideUser Guide ... Reverse Current Protection ... Omicron Lite & O-PHOS…

Post on 15-Jun-2018

212 views

Category:

Documents

0 download

Embed Size (px)

TRANSCRIPT

  • User GuideUser Guidecheck on line for the newest version of this guide. version 1.3

  • The Omicron Lite and O-PHOS vaporizers are the industrys leading, non-flame poweredportable extract vaporizers. The originals to use pure extract oils with no need for carrier agents or cotton. The ceramic cartridges are an advanced design, that provide voluminous vapor clouds while using very little of your extract oils.

    Omicron Lite & O-PHOS Safety LockoutOmicron Lite & O-PHOS Safety LockoutTo toggle the lockout feature of the power button on your Omicron Lite/O-PHOS, quickly press the power button 5 times within 3 seconds until the blue light flashes 3 times. To test the current on/off state, just press the power button once. If the blue light comes on the lockout is deactivated. The safety lockout feature is great to prevent your Omicron Lite/O-PHOS from accidentally turning on.

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    Specs

    Durable connector

    Low Voltage Warning, light will blink 3 times when the cell (battery) voltage is under 3.0v

    Reverse Current Protection

    Short-circuit protection current

  • Page 2

    Plug the USB cable into the USB port on the bottom of the Omicron Lite/O-PHOS.

    2.Unscrew the Omicron Lite/O-PHOSbase cap by turning it counter clockwise.

    Basecap

    Omicron Lite

    Charging Instructions

    1.

    Red Light on means Omicron Lite/O-PHOSis charging

    No Red Light on means Omicron Lite/O-PHOS is not charging or is already charged

    Bottom of Omicron Lite/O-PHOS3.

    Basecap

    Omicron Lite

    Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    Omicron Lite/O-PHOS use a USB pass-thru charging system. This allows them to beused while charging. The Omicron Lite/O-PHOS is always powered by its built in lithium ion cell, even while connected to the USB charger.

    O - PHOS O - PHOS

  • KISS cartridges work best with stable concentrates, solidor thick and not runny at room temperature

    Prerequisites:

    Avoid getting concentrates on any threaded areas

    Non metallic applicator recommended to avoid damage to the heating coil during concentrate application

    1. Pull mouthpiece away from KISS cartridge main body and unscrew mouthpiece holderfrom KISS cartridge main body by turning mouthpiece holder counter clockwise.

    KISS Cartridge Filling Instructions

    Page 3Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    UP TECH

    Mouthpiece

    MouthpieceHolder

    KISS CartridgeMain Body

    O-PHOSKISS Cartridge

    UP TECH

    Mouthpiece

    MouthpieceHolder

    KISS CartridgeMain Body

    Omicron LiteKISS Cartridge

  • Prerequisites:

    2. Load 0.1 - 0.3 grams of concentrate by dropping on to heater coil or gently applyconcentrate using a non metallic applicator.

    KISS Cartridge Filling Instructions

    Page 4Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    Apply Concentrateto shaded area

    WARNING!! Do Not touch the heatingcoils with a metallic applicator ordamage may result.

    Top Down View

  • Prerequisites:

    3. Screw mouthpiece holder back on toKISS cartridge main body by turning mouthpiece holder clockwise. Re-insertmouthpiece into mouthpiece holder.

    KISS Cartridge Filling Instructions

    Page 5Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    UP TECH

    Mouthpiece

    MouthpieceHolder

    KISS CartridgeMain Body

    O-PHOSKISS Cartridge

    UP TECH

    Mouthpiece

    MouthpieceHolder

    KISS CartridgeMain Body

    Omicron LiteKISS Cartridge

  • Prerequisites:

    4. Screw KISS cartridge onto OmicronLite/O-PHOS in a clockwise direction.

    KISS Cartridge Filling Instructions

    Page 6Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    UP TECH

    Assembled KISS Cartridge

    O-PHOSKISS Cartridge

    UP TECH

    Omicron LiteKISS Cartridge

    O - PHOS

    Assembled KISS Cartridge

    Omicron Lite

  • Omicron Lite/O-PHOSPrerequisites: KISS Cartridge already filled with no less than 0.1 grams and no more

    than 0.3 grams of extract and attached to your to your Omicron Lite/O-PHOS

    1. Using your lungs, slowly inhale while holding down the power button for nolonger than 5 seconds at a time. For maximum cartridge life expectancy, wait 20 seconds to allow coil to cool between hits and never run coil dry. Always allow the cartridge to cool between hits.

    !!WARNING!! Cartridge is HOT during use, avoid touching it.

    KISS Cartridge Use

    Page 7

    * PRO TIP

    Keep cartridge standing upright when warm and keep pullingair through it to cool it down faster.

    Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    KISS Cartridge UseOmicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    UP TECHUP TECH

    O - PHOSOmicron Lite

  • Maintenance Instructions

    C.

    B.

    A.

    Depending on your frequency of usage, the electrical contact points should be cleaned at leastonce every 3 - 7 days. The Omicron Lite/O-PHOS vaporizer uses relatively low voltage to operate and even a small amount of residue on the contact points and/or threads can reduce the voltage flow, impeding the performance of your Omicron Lite/O-PHOS. Any residue bridging the gap between the threads and center post on your Omicron Lite/O-PHOS, could cause a very dangerous electrical short resulting in physical injury to yourself and damage to the battery and/or your Omicron Lite/O-PHOS Keep It Clean !

    After every thing is completely dry, lightly touch the contact areas and threads with your fingers. If you feel any tacky areas, please repeat the cleaning procedure steps A - C againuntil all the contact areas and threads are tack free.

    Once cleaned, use the dry end of the cotton swab to help the drying process by gently running it over the areas just cleaned. Be careful that no cotton gets left behind on anysurfaces or threads.

    Using the ISO dampened end of the cotton swab, gently scrub and clean any residue from allthe contact surfaces and threads on all your cartridges and Omicron Lite/O-PHOS The contact surfaces are all the areas that make contact with each other when a cartridge isscrewed into the Omicron Lite/O-PHOS

    To clean the electrical contact points and threads, take a cotton swab (Q-Tip) and dip one endinto some Isopropyl Alcohol (ISO). The higher percentage of purity, the better, try to use asclose to 99% ISO as you can.

    By following these simple maintenance steps, you will keep your Omicron Lite/O-PHOS Vaporizer performing at peak performance.

    Your Omicron Lite/O-PHOS Vaporizer has been designed to be easy to care for and maintain.

    DO: Use ISO to clean the contact areas and threads on all your cartridgesDO: Use ISO to clean the contact areas and threads on your Omicron Lite/O-PHOSDO: Keep your Lithium Ion battery in the Omicron Lite/O-PHOS charged and in good physical conditionDONT: Submerse your cartridge, Omicron Lite/O-PHOS, USB cable or charger in any liquidDONT: Try to clean out a cartridge by filling it with ISODONT: Leave behind any lint or cotton on the cleaned surfaces or threadsDONT: Screw a cartridge on to the Omicron Lite/O-PHOS with out cleaning both firstDONT: Use a longer or different USB cable than the one suppliedAVOID: Using cartridges that have had their coils damaged and/or thin oil put in them, causing them to leak.

    Page 8Copyright Utopia Planitia Technologies 2014 Distributed by www.w9tech.com

    Omicron Lite & O-PHOS User GuideOmicron Lite & O-PHOS User Guide

    UP T

    ECH

    UP

    TECH

    O - PHO

    S

    Omicron Lite

  • Q. My cartridge is leaking, what can I do?A.

    Q. My cartridge is defective, what can I do?A. We recommend to test every cartridge before use by connecting it to the Omicron Lite/O-PHOS

    before filling it with extracts. You can hold down the power button while looking at the coil in adark area. You should see the coil start to glow, let go of the power button immediately to avoiddamaging your KISS cartridge.There are no refunds or exchanges on cartridges for hygienic reasons other than DOA if reported within 24 hours of receipt.

    Q. I hear bubbling sounds when I inhale, is this normal?A. No, bubbling is caused by extract that is too thin at room temperature and/or has impurities in it

    from not being processed / purged correctly. These extracts are not recommended and will causeyour cartridge to clog, leak and generally under perform.

    Q. What types of essential oils can I use?A.

    Q. What are the DOs and DONTs?A. DO: Check your Omicron/O-PHOS for physical damage such as damaged buttons before use

    DO: Pull air through the cartridge SLOWLYDONT: Blow air into the cartridgeDONT: Get any oils, waxes etc. on to the threads during fillingDONT: Excessively heat the KISS cartridge by holding the power button for more than 5 secondsDONT: Inhale hard, you will suck extract into the mouthpieceAVOID: Extract oils that are too thin or runny at