unique smooth sleeve firestop system installation pictorial
TRANSCRIPT
UNIQUE Smooth Firestop Sleeve
System is a multi cable transit for
new horizontal installations of cables
and wires through fire and smoke
rated walls.
The system includes:
(1) 12” EMT sleeve powder
coated RED
(2) large washers
(2) sliding lock couplings
(2) plenum rated bushings
A pair of documentation/warning labels
A package of UNIQUE Intumescent Putty
There is no need for any caulk between the
sleeve and the wall (behind the washers).
Adjust the hardware
to allow for equal
protrusion on both
sides of the
wall. Insert the first
half of the System in
the hole you made.
On the other side of
the wall, install the
washer, sliding
compression
coupling and
bushing.
While holding the
sleeve firmly in the
wall, tighten
the set screw on the sliding compression
coupling.
Now you may use the
sleeve system as if it
were a roller in the
firewall, allowing you
to pull cables
‘unattended’.
This is a real time saver!
Tear the
intumescent putty
supplied with the
system in half. You
will need to apply an
inch thickness to
each end.
If you do not have enough putty, you may
purchase an extra Fill Kit. It is an 18 cubic inch
stick of UNIQUE Intumescent Putty.
When the cables reach their destination, install
an inch thickness of the supplied UNIQUE
Intumescent Putty.
Visit our website for more firestop products
and complete installation pictorials.
https://www.uniquefirestop.com/