tutorial premature hat - wordpress.com · 2018. 2. 20. · tutorial prematur e pants cut out 2 pant...

12
1 Tutorial premature hat Cut out 2 identical pieces Unfold them, put them right sides together, pin in place.

Upload: others

Post on 10-Feb-2021

1 views

Category:

Documents


0 download

TRANSCRIPT

  • 1

    Tutorial premature hat

    Cut out 2 identical pieces

    Unfold them, put them right sides together, pin in place.

  • 2

    Sew together but leave a 2cm (1") opening to turned it right side out later.

    Here's the opening, now turn it right side out.

    Fold in half of the hat. Make sure the seam pokes up a little at the turning hole. Fold down the outer seam

  • 3

    Pin our glue in place to make sure the seam stays in place when you sew

    Sew a straight stitch like this.

    Turn it inside out so the seam is on the inside and you are done. Ida Georgiou 2017-06-25

  • 4

    Tutorial premature pants

    Cut out 2 pant pieces, waist cuff and 2 leg cuffs.

    Pin every part right sides together.

  • 5

    sew side seams and inside seam of the legs.

    Sew the short end of each cuff piece together

    You should now have something like this.

  • 6

    Fold cuffs in half, wrong sides together

    pin the waist cuff right sides together with the legs.

    Pin the leg cuffs, right sides together with each leg.

  • 7

    Sew in place, it can be tricky since they are so small, but go slow and do not forget to remove the pins.

    All done!

    Ida Georgiou 2017-06-25

    Translation: Linda Christianson

  • 8

    Tutorial prematurbody

    Cut out all parts, 1 back piece, 2 front pieces and 2 sleeves.

    Pin sleeves right sides together with the back piece and front pieces.

  • 9

    Sew all raglan seams together and it will now look like this.

    Add binding to wrists, the bottom of the back piece and around the opening on the front pieces.

    It should now look like this.

  • 10

    With right sides together, pin the front pieces to the back piece. I like to glue the edge binding together so it stays in place.

    Press a little extra where you added glue. Then sew together the side seams, starting from the wrist and down.

    Fasten your threads.

  • 11

    Put the body with the big front piece on top of the smaller front piece so the edge binding is on top of each other.

    Measure the distance, 3 – 4 cm between the snaps and make a mark on both bindings.

    Add snaps!

  • 12

    Done!

    Ida Georgiou 2017-06-25

    Translation: Linda Christianson