garage doors

NGTS V2 SET DOOR TRAVEL LIMITS

The limits can be set directly on the power head, or by using the handset (transmitter).

1. Carefully remove the light cover by pulling down on tab at front of unit.2. Press and hold LIMIT button for 3 seconds to begin limit setting mode. Unit will beep 3 times.3. Raise the door to desired open position by pressing and holding UP ADJ button. To �ne adjust this position use buttons UP & DN ADJ (if the door is already in desired opened position proceed to step 4).4. Press LIMIT button once and release �nger to con�rm this position. Unit will beep twice to con�rm the top position is set.5. Lower to the door to closed position by pressing and holding DN ADJ button, �ne adjust using buttons UP & DN ADJ. Ensure the door doesn’t hit the ground hard, maintain 5mm gap between door and �oor.6. Press LIMIT button to set this position. Unit will beep twice to con�rm limit is set. The door will automatically travel between the limits once.7. Replace light cover.

Set using handset (transmitter)

1. Please ensure all 3 jumpers are on the Left side of Key Setting2. Press and hold buttons 1& 3 simultaneously. Hold for 3 seconds Reset3. Raise the door to the open position using press and hold button 2. To adjust this position use buttons 2 & 3 (UP & DOWN). If the door is already in desired opened position proceed to step 4.4. Press button 1 to con�rm this position. Unit will beep twice to con�rm the top position is set.5. Lower the door to the closed position using press and hold button 3, adjust using buttons 2 & 3 (UP & DOWN).6. Press button 1 to set this position. Unit will beep twice to con�rm the closed position is set.7. The door will automatically travel between the limits.

TECHNICAL BULLETINSet Door Travel Limits (NGTS V2 Board)NGTS V2 Tilt and Sectional Door Auto Operator