8/13/2019 TB-IV-10016 Testing the Toshiba VPN Router Before Changing IP's on TAMS Equipment

1/2

ToshibaAmerica Medical SystemsTechnical Bulletin

Ernie Sierra 1 2/6/2006

Modality:IV;CT;MR;NM;UL;VL;XR Document ID: TB-IV-10016

Product Series: PC-Based Aquilion, Vantage,Infinix-i, t.cam, Xario, Aplio

Priority : Information Only

System: PC- BasedAquilion, Vantage,

Infinix-i, t.cam, Xario, Aplio

Issue Date: Feb. 06, 2006

Author : Ernie Sierra Source : InTouch / TSMS

Subject : Testing the Toshiba VPN Router before changing IPs on TAMS equipment

Suggestion:Its good practice to test the Toshiba VPN router first using your laptop,before you change the IP address, subnet mask and default gateway on the any Toshiba

equipment. This procedure will use CTas an example.

Perform the following on your laptop:

1. Change the IP address, subnet mask and default gateway on yourlaptop to the IPaddress of the Scan consoleor Display console. The IP addresses are listed on the

Toshiba VPN Router Installation Sheet (The paper that is in the Toshiba VPN

Router box.)

a. From the Desktop, rightclick on the My Network Places icon.b. Then select Propertiesc. At the Network Connections screen, right click Local Area

Connection, the select Properties.

d. At the Local Area Connection screen click on Internet Protocol(TCP/IP) the click on Properties.

e. Select Use the following IP address. Change to the following:i. IP address: 172.17.X.Y (IP address of the scan console)

ii. Subnet mask: 255.255.255.240iii. Default gateway: 172.17.X.Y(IP address of the Toshiba VPN Router)

f. Click on g. Click on to exit the Local Area Connection properties.h. Exit the Network Connections screen by click on the in the top right

corner.

8/13/2019 TB-IV-10016 Testing the Toshiba VPN Router Before Changing IP's on TAMS Equipment

2/2

ToshibaAmerica Medical SystemsTechnical Bulletin

Ernie Sierra 2 2/6/2006

2. Verify you can ping from the laptop to the devices listed in the VPN order form orthe Router Installation list.

a. On the laptop, click on Startrunb. In the run box type cmdand click OK. Command Prompt will open.c. Example: Type ping 192.168.0.200(This is the IP address for VITREA1).

This is an example. Look on the VPN Order Form or the Router InstallationSheet for IP addresses pertaining to your site.

d. You should get a reply from the IP address. Do this for all of the deviceslisted. You should get a reply from each device.

e. If you are able to ping all of the devices, then change the IP address, subnetmask, and default gateway on the scan and display console. Make sure youadd spand the IP addressto thehost tableon the scan and display console.

f. You can use TB-IV-10001for PC Basedsystems and TB-IV-10002forUNIX Basedsystems for setting-up the scan and display console.