step by step ivngwc 2011 01
TRANSCRIPT
step-by-step January 2011
©by IVNGWC.org - commercial use including excerpts is not allowed - use for educational purposes only under mentioning of this source
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 2 of 6step-by-step IVNGWC 2011-01
step step
Skizze für Drehung und für abtragende Drehung Drehung
1 2
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 3 of 6step-by-step IVNGWC 2011-01
step step
Arbeitspunkt an Schnittlinie von Rundung und Rippenkante aus
Skizze 1 erstellen
Arbeitsebene durch Arbeitspunkt, parallel zur Grundfl äche
3 4
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 4 of 6step-by-step IVNGWC 2011-01
step step
Skizze auf Arbeitsebene. Mittelpunkt der kurzen Seite des Recht-
eckes gleich setzen mit prejeziertem Arbeitspunkt
Extrusion „zwischen“ Grundfl äche und Oberkante
5 6
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 5 of 6step-by-step IVNGWC 2011-01
step step
Abtragende Rotation mit Skizze 1 Rundung
7 8
©by IVNGWC.org -commercial use including excerpts is not allowed -
use for educational purposes only under mentioning of this sourcepage 6 of 6step-by-step IVNGWC 2011-01
step step
Bohrung nach Skizze Runde Anordnung von Bohrung und Rippe.
Fertig
9 10