splitex calibration carbon light
TRANSCRIPT
Seite 1
Calibration of a Carbon ARTEXSplitex Plate Set Carbon (216100C)
Seite 2
(1)Magnet Lifter
(2)Assembly Key
(3)Assembly Plate
(4)Magnet Pot
(5)Socket-head cap screw
(6)Maxilla – Base Plate
(7)Mandibular – Calibration
Plate
(8)Glue Plate
Seite 3
Standard Setting for Calibration
> Incisal Pin set to „0“. > Articulator settings in average :
> Benett angle 10-15°> Condyle inclination 30-35°
Seite 4
>Take out the model plates of Artex articulator.
Seite 5
>Take out the magnets using the magnet lifter.
Seite 6
>Loosen and unscrew the magnet pot with assembly key.
Seite 7
>Screw in the mounting plate instead of the magnet pot down to the lock.
Seite 8
>Unscrew the magnet pot from upper plate>Place the upper plate to the upper arm of the Artex
Seite 9
>Bolt on the upper plate with the socket-head cap screw to the mounting plate in the upper arm of the articulator.
Seite 10
>Screw in the magnet pot to the Splitex upper plate.
Seite 11
>Replace the magnet
Seite 12
>Take out the model plates of Artex articulator.
Seite 13
>Take out the magnet
Seite 14
>Loosen and unscrew the magnet pot with assembly key.
Seite 15
>Screw in the mounting plate instead of the magnet pot down to the lock.
Seite 16
>Isolate the Carbon-surface in the area of the glue plate with a thin layer of vaseline.
Seite 17
>Set in the glue plate with chamfering to the rear> (Important for later separation of the glueing!)
chamfering
Seite 18
>Bolt on the glue plate with socket-head cap screw.
Seite 19
>Put the Artex-Articulator upside down and open the Centric.
Seite 20
>Place the Splitex-Key (216010C) on the upper plate TOP to TOP.
Seite 21
>Place the lower plate with the magnet on the key.
Seite 22
>Clean the glue plate and the lower side (milling) of the lower plate (grease-free)
Seite 23
>Spray the activator into the milling of the lower plate.
>Spray the activator on the glue plate.
Seite 24
>Put on two tracings of glue - left and right of the drillings. Not into the drillings!
Seite 25
>Close the articulator.
>Close the centric.
Seite 26
>Press the articulator frontal for approx. 5 sec. smoothly against the incisal pin.
>leave the articulator in position for 1 h00 before you can unmount the key
>For best results, use after 24 to 48 hours folowing the calibration
Seite 27
>Mounting plates