sims installation
TRANSCRIPT
-
7/26/2019 Sims Installation
1/16
FLOORMAPMFL Floor Scanner
Section 3SIMS Installation Manual
Silverwing UK Ltd , Units 30 - 31 Cwmdu Industrial Estate, Carmarthen Road, Swansea, SA5 8JF Wales, UK
t: +44 (0) 1792 585533 f: +44 (0) 1792 586044 e: [email protected] w: www.silverwingndt.com
-
7/26/2019 Sims Installation
2/16
-
7/26/2019 Sims Installation
3/16
MANUFACTURER:
DISTRIBUTOR:
Floormap Operating Manual Section 3
Manual Version 4.0
SIMS Software Version 4.0
Copyright 2014 by Silverwing (UK) Ltd
The text, figures and programs have been worked out with the utmost care. However, we cannot
accept either legal responsibility or any liability for any incorrect statements which may remain,
and their consequences. The following documentation is protected by copyright. All rights
reserved. No part of this manual may be reproduced or transmitted in any form or by any means,electronic or mechanical, including photocopying and recording for any purposed without the
express written permission of Silverwing (UK) Ltd. The rights of reproduction through lectures,
radio and television are also reserved. The software and hardware descriptions referred in this
manual are in many cases registered trademarks and as such are subject to legal requirements.
Silverwing (UK) Ltd reserves the right to continue developing the system and software without
documenting each individual case. Silverwing (UK) Ltd will be happy to determine whether this
manual is up-to-date. Silverwing (UK) Ltd holds no responsibility for any damage or destruction
caused when following instructions within this manual.
This manual is part of the original documentation supplied with the Floormap system.
Silverwing (UK) Ltd.
Unit 30 - 31 Cwmdu Industrial Estate,Carmarthen Road, Swansea,
Wales, UK, SA5 8JF.
Phone: +44 (0) 1792 585533
Fax: +44 (0) 1792 586044
Email: [email protected]
Web: www.silverwingndt.com
-
7/26/2019 Sims Installation
4/16
-
7/26/2019 Sims Installation
5/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-1Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
TABLE OF CONTENTS
1 Introduction ............................................................................................................................... 22 SIMS Software Licence Terms ................................................................................................ 23 Minimum System requ irements .............................................................................................. 24 Installat ion of the Reporting Sof tware ................................................................................... 3
4.1 Software Prerequisites ............................................................................................................ 34.2 Starting the Software Installation Interface ............................................................................. 34.3 Installing the SIMS and Prerequisite Software ........................................................................ 44.4 Running the SIMS Software in admin mode ........................................................................... 64.5 Loading the SIMS Software .................................................................................................... 6
5 Reporting Software Act ivation (Ful l-Version only) ............................................................... 75.1 Activation Process ................................................................................................................... 7
-
7/26/2019 Sims Installation
6/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-2Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
1 IntroductionThis section of the operating manual explains how to install the SIMS Software provided with the
purchase of a Floormap system, designed and manufactured by Silverwing (UK) Ltd. There are two
versions of the reporting software that exist, a Full-Versionis licenced to the inspection organisation
who purchased the Floormap system, and a Read-Only version for use by the end client / report
viewer.
2 SIMS Software Licence TermsThe SIMS full-version of software is activated on a laptop / desktop computer using an activation key
supplied by Silverwing (UK) Ltd. The maximum number of activation keys supplied by Silverwing
(UK) Ltd is three per Floormap system. Additional activation keys are available and can be
purchased by contacting Silverwing (UK) Ltd. The SIMS read-only version of software does not
require an activation key and can be freely issued by the licensed owners organisation to their
inspection clients at the licensed owners discretion.
3 Minimum System requirementsThe following specifications are the minimum operating requirements for the SIMS Software.
Microsoft Windows Vista /7/8/8.1 32bit or 64bit operating system
Microsoft Windows 7 Ultimate, Professional, or Home Premium or Microsoft Windows
Vista Professional or Home
2 GHz Intel or AMD processor, 32-bit (x86) or 64-bit (x64) capable CPU.
NVidia GeForce with minimum 256 MB RAM or ATI Radeon with minimum 256 MB RAM
1024 x 768 display resolution (1440 x 900 or higher recommended)
4GB RAM (6GB recommended for 64-bit),
Microsoft .NET framework (supplied),
Microsoft DirectX9 (supplied),
Microsoft XNA framework (supplied),
100MB Hard disk space for installation, recommended 500GB for storage of tank data.
Windows compatible mouse & keyboard
USB support for data transfer using the supplied high speed USB Flash Drive.
-
7/26/2019 Sims Installation
7/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-3Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
4 Installation of the Reporting Software
4.1 Software Prerequisites
For the SIMS Software to function correctly it requires additional software applications:
Microsoft Windows Installer 4.5 Microsoft .NET Framework Version 4.0
XNA Framework Version 4.0
Copies of relevant versions of the pre-requisite are included on the installation CD and installed as
required during the installation process.
4.2 Starting the Software Installation Interface
To install the software from the Installation CD, insert the CD into the computer CD drive. A CD
autorun window should appear (Figure.1). Click Run SIMS.exeto load the installation interface screen
(Figure.2).
Figure 1CD Autorun window
If the CD does not Autorun, open My Computerand then double click the CD drive to view the
contents. Double click on the SIMS.exeicon to load the installation interface screen.
Figure 2 Installation in terface screen
-
7/26/2019 Sims Installation
8/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-4Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
4.3 Installing the SIMS and Prerequisite Software
To begin installation of the SIMS software click on the Install SIMS Reporting Software button
(Figure 2). The installation package automatically prompts to install required pre-requisite software.
Accepting these installs allows required pre-requisite software to be installed. Once the software has
been installed, the SIMS installation wizard appears.
Step 1:Click Nextto proceed with the installer.
Figure 3Setup Wizard
Step 2:Select a location to install the Software.
Figure 4 Setup Wizard
-
7/26/2019 Sims Installation
9/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-5Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
Step 3:Click Next to start the installation.
Figure 5Setup Wizard
Step 4:Click Close. You have now successfully installed the SIMS software.
Figure 6 Setup Wizard
-
7/26/2019 Sims Installation
10/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-6Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
4.4 Running the SIMS Software in admin mode
Once installed the software generates a desktop shortcut icon which can be used to begin the SIMS
Software. Before the software can be started it must be manually set to run as an administrator mode
To manually set administrator mode:
1. Right click on the SIMS icon then select Properties.
2. Navigate to the Compatibility Tabof the properties window.
3. Tick Run this program as an administrator
Figure 7Run as Admini strator
4. ClickApplyand Ok.
IMPORTANT!If the software is not set to run in administration mode then thesoftware cannot be activated and the software may fail to load.
4.5 Loading the SIMS Software
To load the SIMS Software, either double click on the desktop icon or navigate through the windows
start menu:
StartAll ProgramsSilverwing(UK) LtdSIMSSIMS
-
7/26/2019 Sims Installation
11/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-7Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
5 Reporting Software Activation (Full-Version only)
When the Full-Version of the SIMS software is loaded for the first time the Floormap Product
Activation window appears. The software requires activation prior to use and must be activated using
an activation key obtained from Silverwing (UK) Ltd. This is to prevent user from installing the Full-
Version of software on more than three separate computers as per the software license conditions.
5.1 Activation Process
To activate the SIMS software, all fields in the Floormap Product Activation window (Figure 8) must
be entered.
Figure 8Floormap Product Activation Window
To complete:
1. Enter a user name in the Userfield.
2. Enter a Company name in the Companyfield.
3. Select the required Floormap Versionfrom the dropdown box.
4. Enter the serial number for the Floormap into the Floormap Serial Number.
5. Once the above fields have been filled, click the Generate Serialbutton. This will generate a serial
number which is unique to the computer. If an error message appears please check that the
software is set to run in admin mode.
6. Click on the Copy information (paste in email)button.
This copies the User, Company, Floormap Version, Floormap Serial Number, Reporting Software
version number and the unique serial number from the Floormap Product Activation window as
text. This can be pasted into an email, Microsoft Word document, or equivalent.
-
7/26/2019 Sims Installation
12/16
Floormap Operating Manual Rev 4.0 Section 3SIMS Installation
3-8Doc Ref:OM-FM-S3
Rev: 4.0Date of Release: 23/06/2014
7. Contact Silverwing (UK) Ltd with the information obtained by clicking Copy information (paste in
email)button (exactly as it was originally typed):
User
Company
Floormap Version
Floormap Serial Number
Reporting Software Number
Version Number
Serial
8. An activation key is provided by Silverwing (UK) Ltd from the provided information (please allow
up to 24 hours from the time of the activation request).
9. Ensure that the correct information is shown in the User / Company / Floormap Serial Number /
serial numberfields then enter the Activation key into the Enter ProvidedActivation key herefield.
10. Click Verifyto complete the activation process.
If successful, a Verification Successfulmessage will be shown, if not successful, a VerificationNOT
Successful message will be shown. When successful, the Verify button will also change into
Continue; click this to close the activation screen.
A permanent record of the User / Company / Floormap Version / Floormap Serial Number /
Reporting Software Number / Version Number / Serial / Activation Key must be kept. This
information will be required if the software is reinstalled or updated in future.
-
7/26/2019 Sims Installation
13/16
Notes:
-
7/26/2019 Sims Installation
14/16
-
7/26/2019 Sims Installation
15/16
-
7/26/2019 Sims Installation
16/16
Silverwing UK Ltd - (Head Office)Units 30 - 31Cwmdu Industrial EstateCarmarthen RoadSwansea, SA5 8JFWales, UKt: +44 (0) 1792 585533
f: +44 (0) 1792 586044e: [email protected]: www.silverwingndt.com
Silverwing Middle East LLCP. O. Box 75950DubaiUnited Arab Emiratest: + 971 4 360 6751f: + 971 4 360 6124e: [email protected]
w: www.silverwingme.com
Silverwing Africa (PTY) LtdPrivate Bag X1Postnet Suite 419Melkbosstrand7437South Africat: + 27 21 557 5740
f: + 27 21 557 4354e: [email protected]: www.silverwingafrica.com
Silverwing USA IncSuite 1202911 South Shore BlvdLeague CityTexas77573USA
t: + 1 832 531 0092e: [email protected]: www.silverwingndt.com