samsung gt-m2310 11 disassembly and assembly instructions

8/19/2019 Samsung GT-M2310 11 Disassembly and Assembly Instructions

http://slidepdf.com/reader/full/samsung-gt-m2310-11-disassembly-and-assembly-instructions 1/6

SAMSUNG Proprietary-Contents may change without notice

11. Disassembly and Assembly Instructions

11-1

This Document can not be used without Samsung's authorization

1) Disjoint HANDSET back side 4 points SCREW.

(Pay attention to scratch and damage.)

1) Lifts and separates Rear with picture after

separate all Lockers.

(Takes care and lifts top HooK.)

1) Disjoint HANDSET back side 2 points SCREW.

(Pay attention to scratch and damage.) 1) Separate Main connector and Side Key.

11-1. Disassembly Instructions

1) Disassemble Screws

1) Remove REAR

3

1) Disassemble Screws

4

1) Separate PBA Ass'y and side key




Disassembly and Assembly Instructions

11-2


1)Separate shield-Can after SCREW of 2 points

decomposition.1)Separates Keypad from Front.

1) Hinge part beats to strong pin end and disjoints

Front.

1) Separates SCREW CAP and disjoints SCREW.

2) Separate with arrow direction using instrument.

5 6

7 8

1) Remove Shield-Can 1)Remove Keypad

1)e Front1)Remove UPPER and LOWER





11-3


1) Speaker and Receiver are detached easily

because there is no Tape, and separates using

tweezers in the case of Motor.

1) Pays attention to back side two faces Tape of

camera and separates camera.

Pays attention to Lower LCD placing area

circumference moisture prevention Tape and

separates LCD Ass'y.

(When separate, pay attention to Con To Con damage)

9

1) MOTOR/SPEAKER/RECEIVER 1) Separate LCD Ass'y





11-4


1) Assemble Speaker, Receiver, Motor after

LCD assembly.

(When assemble, pay attention to Con To Con

damage. )

1) Pay attention to both Hook of Lower and

Upper and assembles.

1) Tighten a Screw after Lower assembly.

2) Attach Screw Cap.

1) Assemble Front and LCD Ass'y.

(When assemble, pay attention to hinge and

Con To Con damage)

11-2. Assembly Instructions

2

3 4

LCD Ass'y Front Ass'y

SCREW UP Lower





11-5


1)Assemble so that keypad is arrived safe to all

2) In particular, when assemble center of keypad,

take care so that it is same picture and assembles.

1) Tighten a Screw of 3 points as picture after

Shield-Can assembly.

1) Assemble connector and Side Key after

Board safe arrival.1) Tighten Screw 2 points.

5 6

8

Put on the Keypad Shield-Can

Put up SIDE KEY and CON TO CON Assemble Screws

7





11-6


1) When assemble Rear, pay attention to top

portion Hook and assembles with picture.

1) Confirm after Rear safe arrival that all hooks are

combined.

2) Tighten Screw 4 points.

9

Assemble Rear Assemble Screws

samsung gt-m2310 11 disassembly and assembly instructions

Documents