Sample Metal components review.

SUB21261-02 (W-271AVB)The counter sink on the holes on the cover

panel(MPM20341)for the screw need to be widen. This is to ensure that the screw head sits flush with the panel and does

not stick out

(W271AVB)IMPERFECTIONS IN THE POWDERCOATING.

(W-343B)

1 out of 4 caster plates are welded in the wrong position.

This is the plate that is welded correctly.

MPM50376-BR180 (W-343B)

BURN MARK ON THE BASE. CORNERS ON TOP SURFACE OF BASE ARE NOT POLISHED TO A CLEAN 45 DEGREES.

MPM50377-BR180 (W-343B)

NOT EVENLY POLISHED. BURN MARK ON THE END CAP.

MPM91183-09W (W-271VA)

VISIBLE GRIND MARKS THROUGH THE POWDER COATING. CAME IN WITH SCRATCHES .

MPM20345-09W (W-271VA)

HOLE IS OBLONG AND CAUSES THE SCREW TO BE LOOSE INSIDE THE HOLE.

MPM20314-09W (W-271VA)

THREADS ON THE WELD NUTS ARE 10MM AND VIRA DRAWING CALLS FOR THEM TO BE 3/8-16.

WELDNUTS WERE WELDED FLUSH WITH THE END OF THE TUBE AND SHOULD HAVE BEEN RECESSED 1/8” AS PER VIRA DRAWING.

MPM10537-09W (W-271VA)

Flanges came in with wavy polishing on the top surface.

MPM20324-09W (W-273VAB)

WAVY POLISHING ON TOP SURFACE WHERE BUSHINGS ARE TIG WELDED. OBLONG THRU HOLE.

(W-273VAB)ID OF METAL SLEEVE WERE MEASURED AT .262”DIA. VIRA DRAWING CALLS IT TO BE .280”DIA HOLD.

PUCK FACE ON THE RIGHT IS OUR VENDOR’S QUALITY. PUCK FACE ON THE LEFT IS VIRA REWORK QUALITY.

MPM02282-09W (W-350AV2)

1 WAS MADE THE CORRECT LENGTH OF 41 5/8”. THE OTHER ONE WAS MADE 44”L WHICH IS INCORRECT.

MPM02283-09W (W-350AV2)

1 OUT OF 4 WAS MADE THE CORRECT LENGTH OF 43 5/8”. THE OTHER 3 WERE MADE 43 3/8”L.

STRETCHERS CONTAIN IMPERFECTIONS IN THE POWDER COATING.