sadowskyonboardbasspreamp - bass gear direct · 2015. 8. 22. · sadowsk y gui tars ltd. 210741st...
TRANSCRIPT
SADOWSKY GUITARS LTD.2107 41ST AVENUE • 4TH FLOORLONG ISLAND CITY, NY 11101
—PHONE (718) 433-1990FAX (718) 433-1993
www.sadowsky.com [email protected]
We recommend installation by aprofessional guitar technician.
On a typical J-style bass, the output jack needs tobe moved to the side of the body and a batterycompartment must be installed in the rear of thebass. System operates on a single 9V battery. Noadditional headroom is gained by using 18 volts.
For other configurations, remove the plate. Potscan be configured for a 4-in-line or a diamondpattern. Threaded potentiometer bushing length is3/8" for rear control cavity installation.
Pickup leads should be spliced onto black andwhite wire connectors located on the blendcontrol. Heat shrink tubing is included to insulateexposed solder joints. Swap connectors toreverse direction of blend control.
Bridge ground should be soldered to the back ofthe blend pot.
SPECIFICATIONSFrequency Response 5Hz to 50KHzPower Source One 9V BatteryBattery Life 870 Hours*Bass Control +13db Boost @ 40HzTreble Control +13db Boost @ 4KHzTotal Harmonic Distortion 0.1% @ 1KHzInput Impedance 1 Meg OhmOutput Impedance 1KΩ
*NOTES: Battery will drain whenever a cable is inserted into the input jack. Switching to bypass willnot conserve battery life. Under normal use, you should expect about six months of battery life. TheVintage Tone Control operates in both active and passive modes.
www.sadowsky.com/store/batt-o-meter.html
We highly recommendthe BATT-O-METER for
easy testing of batterylevel via the output jack.
Sadowsky Onboard Bass PreampMaster Volume / Blend / Vintage Tone / Treble and Bass Boost
Pull up on tone knob for true bypass of preamp