running right safety meeting. dismounting running right

13
RUNNING RIGHT SAFETY MEETING

Upload: lizbeth-lyons

Post on 16-Dec-2015

221 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

RUNNING RIGHT

SAFETY MEETING

Page 2: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

DismountingDismountingRUNNING RIGHT

Page 3: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

The hazards associated with mounting and dismounting from our work locations are common. This activity represents a real potential for an injury every time we perform our work duties!

A 43-year-old contractor truck driver with 10 years experience was fatally injured at a lime operation. The victim was found lying on the ground by the rear bulk trailer parked near an access rack. The rack was used to access the hatches on top of the trailer. The victim was hospitalized and died of his injuries on Jan. 22, 2008. Although there were no eyewitnesses, the victim's injuries were consistent with a fall from an elevated location.

Page 4: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

RUNNING RIGHT

Merely being aware of the hazard is not adequate; each of us must consciously work toward avoiding accidents associated with mounting and dismounting from equipment and stationary work locations. An analysis of mining industry accidents reveals a significant number of mounting /dismounting mishaps.

Page 5: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

Most of the injuries associated with this type of accident involve getting on and off mobile equipment and climbing ladders, stairs or other elevated workstations. In most cases, the injuries associated with mounting and dismounting accidents involve slips and falls.

Page 6: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

When climbing onto or off of equipment, both hands should be free of material. Don’t attempt to climb up or down from work locations while carrying supplies, lunch buckets, tools or other items. If it is necessary to have these or other items, hoist them up after mounting or have a co-worker hand them to you. Do not attempt to ascend or descend with anything in your hand.

Page 7: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

Using the “three-point contact” rule will eliminate most injuries associated with mounting and dismounting. This means always having two hands and one foot or two feet and one hand in contact with the equipment. This certainly does not mean that we should walk on “threes” while walking up an inclined area. However, when handrails or grab rails are available, utilizing this simple “three-point contact” rule will go a long way toward preventing accidents.

Page 8: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

Prior to mounting and dismounting, employees should check their shoes/boots for adequate traction. Footwear should be chosen to afford the maximum amount of traction possible and with consideration for the hazards likely to be encountered on the job.

Page 9: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

When obstacles are present in the normal route(s) of travel or at workstations, they should be removed. Slipping or tripping hazards in walkways have contributed to a large percentage of the lost time accidents at our operation. Practicing good housekeeping, particularly in relation to walkways, prevents accidents. When walkways are cluttered with supplies–coal or debris–a real possibility of an accident exists.

Page 10: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

Remember, use the three-point rule when mounting or dismounting from equipment, climbing ladders and ascending or descending inclined walkways or stairs. Look and plan ahead. Observe the walkway a few steps in advance of your location. When obstacles are detected in the walkways –remove them. Your action may prevent an accident. Be alert for other slipping and tripping hazards like mud, grease, etc.

Page 11: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

Don't jump when getting off equipment. Watch your footing and use the handholds. Always keep safe practices in mind.

It is often the little things that cause injuries.

Page 12: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

If you can’t afford to do something right, then you can’tafford to do it wrong.

Page 13: RUNNING RIGHT SAFETY MEETING. Dismounting RUNNING RIGHT

SafetyShare.org disclaimer

from SafetyShare.org13

Material presented on the National Mining Association's SafetyShare.org website is intended for information purposes only and does not constitute advice. The National Mining Association tries to provide content that is true and accurate as of the date of writing; however, we give no assurance or warranty regarding the accuracy, timeliness, or applicability of any of the contents. Visitors to the SafetyShare.org website should not act upon the website's content or information without first seeking appropriate professional advice.

The National Mining Association accepts no responsibility for and excludes all liability in connection with browsing this website, use of information or downloading any materials from it, including but not limited to any liability for errors, inaccuracies, omissions, or misleading statements. The information at this website might include opinions or views which, unless expressly stated otherwise, are not necessarily those of the National Mining Association or any associated company or any person in relation to whom they would have any liability or responsibility.