NOTE: While the RUGER® 9ETM pistol has fixed sights, it has the same basic

operational characteristics as all other SR-SERIES pistols.

AMMUNITIONThe RUGER® 9E

TM pistol is chambered for the 9mm Parabellum cartridge. Do notattempt to load any other cartridges into the magazine or chamber of the pistol.

9E 6/14

INSTRUCTION MANUAL INSERT FORRUGER® 9E

TM

SUPPLEMENTAL PARTS LIST & EXPLODED VIEWPlease See Pages 37 - 39 of the Enclosed Instruction Manual For All Other

Parts Lists and Exploded View Drawings

Key Part Name Part No. Model

* 1 Slide VS00101 9E2 Front Sight VS03230 9E12 Rear Sight VS03330 9E21 Striker Cover VS02310 9E

* Parts so marked must be factory installed.

– SEE OTHER SIDE FOR LOCKING DEVICE INSTRUCTIONS –

LOCKING DEVICEINSTALLATION INSTRUCTIONS

It is important to use the locking device on your Ruger® firearm!

Keep the muzzle pointed in a safe direction and your fingers outside the triggerguard at all times!

To Install the Factory-Supplied Locking Device:1. Remove the magazine from your pistol.

2. Open the action completely, and verify that the firearm is completelyunloaded and contains no cartridges or cartridge cases!

Use the slide stop to keep the action open during installation of the lockingdevice.

3. Insert the cable directly to your pistol as shown in Figure 1.4. To lock: With the key turned to the farthest clockwise position, insert the

loose end of the cable into the lock. Turn the key counterclockwise andremove the key.

5. Once the lock is securely closed, pull firmly on the lock to test the connec-tion and be sure it is locked. Do not leave or store your firearm with the keyin the lock! Store your locked unloaded firearm and the key in secure, sepa-rate locations, away from ammunition, children, and unauthorized adults.

Correct Installation of Cable LockFor Ruger® 9E™ Pistols

Figure 1