Fully mechanical refurbish and upgrade of the electronic control box of Pav-Pac Laboratory

Compactor.

The challenge has been to supply the best service that meet all your business requirements, including performance, reliability, and maintainability with critical spare parts that are readily available locally and with technology that is readily serviceable.

Mechanical rebuild of your machine involve the following

steps: 1.  Fully dismantle machine, clean inspect all components 2.  Replace all pneumatic system with parts readily available 3.  Replace all limit , reed switches 4.  Service table assemble, replace Sprag clutches, seals 5.  Service latching mechanism 6.  Assemble all parts 7.  Test run

Control box upgrade 1.  Replace existing control box with a new control box,

this unit will be using existing plug configuration as current unit.

2.  Supply and install Panasonic PLC 8 in 6out 3.  Supply and install RedLion Kadet Operator Interface

850 4.  Supply and install 24vdc power supply 5.  Supply and install safety relay/switch 6.  Supply new enclosure 7.  Test run

Control panel

Setting counter

Touch screen

Replace main pneumatic cylinder Old cylinder New cylinder

Replace all solenoids- Standard Old solenoids- obsolete New solenoids

Supply solenoid manifold Old solenoids –obsolete

New solenoids

Safety Modifications Safety Relay Safety switch

Replace locking cylinder Old cylinder Two New cylinders

Replace Slew solenoid Old solenoid New Solenoid

Replace turn table solenoid Old solenoid New solenoid

Replace all reed switches Old switches New switches

Replace air service unit Old unit New unit

Service turn table

Replace clutch &seals