Replacing the Maintenance Kit

HP Printers

OIT lab services

Parts of the Maintenance Kits

1. The Fuser

2. Feed/Pickup Rollers

3. The Transfer Roller

Exit

Accessing the Parts

Top CoverTransfer Roller

Paper TrayFeed/Pickup Rollers

Left DoorFuser

ExitResetting the page count

Removing the Fuser

• Open the left door• Remove the duplexer

by pushing down on the green tab and slide it out.

Exit

Removing the Fuser

• Release the fuser by turning the blue levers down.

• Don’t turn the gray levers downward.

• Use the finger tabs, lift the fuser up and slide it out of the printer.

Blue Lever Finger Tab

Exit

Replacing the Fuser

• Remove the orange packing spacers (one on each side) from the new fuser.

• Slide the new fuser firmly into place.

• Be sure it is pushed in the printer beyond the lip of its supporting frame and is completely seated.

Exit

Replacing the Fuser

• Rotate the blue levers up to lock the fuser in place.– Repeat step 8 if levers do not rotate.

• Reinstall the duplexer.• Push the duplexer into the printer until it

locks in place. You will hear a clicking sound.

• Close the left door.

Exit

Accessing the Feed Rollers

• The feed rollers are inside the paper tray area

• Open tray 2 and pull it out until it stops.

• Remove the tray by lifting up while pulling the tray away from the printer.

• Repeat above steps for tray 3.

Exit

Removing the Feed Rollers

• Pinch the protruding tab

• Slide the roller off the shaft

• Replacement is the reverse of installation.

• Slide the new rollers onto each shaft until they click into place.

Exit

The Transfer Roller

• Open the top cover and remove the toner cartridge

• The transfer roller is located under the toner

• Caution: To prevent damage to the roller DO NOT touch the black foam roller.

Exit

Remove the Transfer Roller

• Grasp the blue gear on the left and lift it up just enough to clear the retainer clip.

• Slide the transfer roller left to release the right end.

• Remove the transfer roller assembly.

Exit

Replace the Transfer Roller

• Place the right end of the new shaft into the hole on the right side.

• Slide the roller to the right until the blue gear on the left is in place.

• Snap the blue gear into place.

Exit

Lock the Roller Guide

• Press the metal and black plastic guide until it snaps into place.– Note: If the guide is not

snapped into place jams will occur.

• Replace toner cartridge and close top cover and close the top cover.

Exit

Resetting the Page Count

• Close up the printer and turn the power on.

• At this point, reset the page count and printer message.

• For more information on resetting the page count visit the LM page.

Exit