relay installation – 2013 & newer volvo · 2016. 9. 19. · omnitracs xrs relay installation...
TRANSCRIPT
Relay Installation – 2013 & Newer Volvo
January 2016
Omnitracs XRS Relay Installation
©XRS Corporation Omnitracs XRS Relay Installation: XR-9801 Rev H Page 2
Contents Overview........................................................................................................................................... 3
Access to Wiring Panel ...................................................................................................................... 3
Power Connections............................................................................................................................ 4
Wiring to J1939 (Volvo) Specifications ............................................................................................... 5
Relay Placement ................................................................................................................................ 7
Copyright © XRS Corporation. All Rights Reserved. This content is for informational or instructional purposes only. This c ontent may be changed or superseded without notice, and is not part of any XRS product or services warranty.
Omnitracs XRS Relay Installation
©XRS Corporation Omnitracs XRS Relay Installation: XR-9801 Rev H Page 3
Overview
Use this guide to connect a Relay to a 2013 & newer Volvo truck with hardwire cable CB-0175-02.
NOTE: The supplied cable may have either a red or orange cable color, and may appear differently than the image.
Access to Wiring Panel
Remove the fuse panel screws behind the vehicle’s dashboard cup holders and open the vehicle’s fuse panel cover.
Omnitracs XRS Relay Installation
©XRS Corporation Omnitracs XRS Relay Installation: XR-9801 Rev H Page 4
Power Connections
1. Find slot B1-1 in the vehicle’s fuse panel (B1-2 can also be used if B1-1 is not available).
2. Insert the red or orange (power)
and black (ground) combination wire
into B1-1.
3. Using the document located on the back
of the fuse panel cover, locate the fuse
corresponding to B1-1 (or B1-2, if used).
Ensure this fuse location contains at least
a 2 Amp fuse. If not, one must be
installed.
Omnitracs XRS Relay Installation
©XRS Corporation Omnitracs XRS Relay Installation: XR-9801 Rev H Page 5
Wiring to J1939 (Volvo) Specifications
1. Locate the gray J1939 vehicle connector near the fuse box (shown below).
2. Remove the
resistor plug from
the connection.
Save the plug for
reinsertion later.
Omnitracs XRS Relay Installation
©XRS Corporation Omnitracs XRS Relay Installation: XR-9801 Rev H Page 6
3. Connect the smaller gray connector (green (J1939L) and yellow (J1939H) wires) to the
vehicle’s J1939 gray connector.
4. Insert the saved plug into the remaining connection.
5. Secure any loose wires with zip ties.
Omnitracs XRS Relay Installation
©XRS Corporation Omnitracs XRS Relay Installation: XR-9801 Rev H Page 7
Relay Placement
1. Route the 15-pin end of the
cable up and through the dash
so it is available for
connection to the Relay.
2. Close the fuse panel cover.
3. Securely attach the cable to the Relay.
4. Use the sticky strips on the bottom of the Relay to securely attach the unit to the dash.
Ensure the unit has an unobstructed view of the sky.