quickstart guide pri thank you ph2100 - camping … guide please review this quick start guide to...
TRANSCRIPT
®
QuickStart Guide
Please review this Quick Start Guide to begin using your generator. To fully understand and safely operate this product, please review the warnings and complete detailed instructions in the Owner’s Manual.
Thank you For joining the PoWerhoUSe FAMiLY
Please refer to the Owner’s Manual when you see this icon for important details and additional information.
13
www.powerhouse-products.com Rev. 2012-08-01
Avoid waterKeeP AWAY FroM rAin, SnoW AnD other Wet ConDitionS
Use outdoors onlyProDUCeS CArbon MonoxiDe — CAn CAUSe DeAth or SerioUS injUrY
FlammableKeeP AWAY FroM SMoKing MAteriALS, SPArKS, & SoUrCeS oF CoMbUStion When reFUeLing
High altitudes / Extreme temperaturesreFer to the oWner’S MAnUAL For SPeCiFiC reCoMMenDAtionS
Keep levelALWAYS oPerAte on A LeveL SUrFACe
In emergencyPUSh the engine SWitCh to OFF PoSition to StoP engine – With or WithoUt A LoAD.
Battery safetyreFer to the oWner’S MAnUAL For MAintenAnCe AnD SAFetY reCoMMenDAtionS
Inve
rter
G
ener
atorP
H21
00
PRi
What you need to
Get startedOil (15.6 oz of 15W-40) Use 0W-40 in very cold weather
Gasoline (1.3 gal.)
Funnel
Phillips screwdriver
Battery charger If you do not have a charger we recommend the Powerhouse TC2-P charger (#19674)
12
13
Box
Contents
Please take a few moments to register your unit at www.powerhouse-products.com/register.
If you have a problem with this generator, do not return it to the store where you purchased it. For warranty support call 877-544-4449, 8am to 6pm ET, or email us at [email protected].
11
1. PH2100PRi generator
2. Oil jug
3. 2 keys
4. 2 remotes
5. Oil drain pipe
6. Spare fuse
7. Spark plug wrench
8. Screwdriver
9. Spare spark plug
10. Battery charge kit
11. Owner’s manual 11
5
7
9
2
1
3
4
6
10
8
©Copyright DTS Manufacturing / The Coast Distribution System, Inc. 2012
Control panel
Spark plug access door
Gas cap access door
Startergrip
Primer bulb
Battery access door
Maintenancedoor
Fuelvalve
Overload light (red)Run light (green)Low oil alarm light (red)
Economy switch
Remote switchGround terminal
Battery charge receptacle
Stop button (red)
Ignition switch
Parallel data port
120 V circuit breaker
Parallel receptacle
120 V duplex receptacle
Battery charge circuit breaker
Overload reset button (green)
Remote on indicator
Initial setup
(continued)
Remove battery access door
Locate battery wiring harness
Connect battery wiring harness to main wiring harness
Replace battery access door
Remove maintenance door
12Add oil Add 15.6 oz. (460 ml) of oil or fill to full mark on dipstick
Remove dipstick
Connect battery charger to DC receptacle
Charge the battery for 3 hours or until fully charged
3 HOURS
Oil resevoir
Initial setup (continued)
Replace dipstick
Replace maintenance door
Add gasoline Use gasoline with an octane rating of 87 or higher
13
Operation
Turn remote switch off
16
Connect appliances
For remote system in-structions, refer to page 18 of the owner’s manual
18
20
Turn key to start
For additional starting options refer to pages 16-18 of the owner’s manual
Disconnect appliances
Open fuel valve
Pump primer bulb 15 to 20 times (initial startup only)
Shutdown
In emergency push and hold the STOP button until the engine is off
Disconnect appliances
Turn economy switch on
Turn key off
Turn remote switch off
Close fuel valve