product: lambda light. product portfolio of mounting systems mounting systems on-roofin-roof fat...
TRANSCRIPT
Product portfolio of mounting systems
Mounting systems
On-roof In-roof Fat roof Open terrain
Tau
Alpha
Theta
Kappa
Zeta
Lambda Light
Lambda
Sigma I
Omega
Sigma II
Gamma
Mounting Systems GmbH Product portfolio
Stand 110530
Designed for flat roofs with limited permissible additional load capacitiy
• Aerodynamic, optimized system, requirering substantially less ballast than conventional flat roof systems
• Intelligent, interlocking system – Few single components– Simple installation
• Comprehensive project support – For efficient quotation and planning– For statical security
Lambda Light Flat roof system
Stand 110530
Lambda Light – Flexible, efficient, safe
• Suitable for configurations of min. 2 rows
– Min. 10m²– Lowest ballast categories red
at configurationachesErreichung der ni of min.5x5 modules
– The bigger the installation, the lower the average additional load
• For landscape installation of framed modules
• Standard pitch: 15° (others on request)
Stand 110530
Lambda Light – components
• Protective mat
• Ground profile
• Pitched profile
• Back sheet
• Side flashing
• Base rail with clamp and joiner piece
• Module end clamps
• Small parts
Stand 110530
Lambda Light – Principle of a light-ballasted system
• Reduction of the regular load requirements exacted in the applicable regulations and standards for wind loads through
– Interconnection of all system parts– Aerodynamically advantageous design
• Low landscape orientation• Lateral and back closures• Specific gap on top
• Planning safety through– Wind channel testing, FEM-calculations– Tests for applicable sliding values
=> Many roofs with limited permissible additional load capacity can be used for PV installation; formerly unsuited roofs become potential ‚PV-roofs‘
Stand 110530
Lambda Light – Support
• Planning process more complex than traditionally, due to higher security risks in case of misinterpretation
• High Mounting Systems support level:
– Support for the configuration of the installation, including roof-specific testing of sliding
– Detailed calculation of necessary ballast– Exact layout plan for all components
Stand 110530
Lambda – clever details 1
• Main components made of Aluminium sheets:– Combining low weight and high resistance
• Simple transport• Low quantities of material
– Dubble corrucation of ground profile provides space for ballast
– Great optics
• Keyhole – type fixing spaces for rapid and safe installation of the clamps
• Upstands in the ground profiles facilitate exact positionning
– Short installation times, exact overlap withoutmeasuring
Stand 110530
Lambda – clever details 2
• Selfdrilling screws; no metal slivers– Protection of the roof
• Universal module end clamp – Proven Quickstone technology– One component for all frame heights
• Version without module support rail– For modules that can be clamped at the corners– Cost reduction by approx. 15%
Stand 110530
Lambda Light – at a glance
• Light ballasted system for landsccape installation of framed modules, especially suited for big installations
• Status of product launch– Testprojects successfully installed– Start of standard sales in Q3/4
• Clevere design:– Few, lightweight components– Modular system, built for speady
installation– Competent support