pr-0087 cisaille manual flexibar cutting tool
TRANSCRIPT
INSTRUCTION SHEET
WARNING: 1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your ERICO customer service representative. 2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 3. All instructions must be completely followed to ensure proper and safe installation and performance. 4. Improper installation, misuse, misapplication or other failure to completely follow ERICO’s instructions and warnings may cause product malfunction, property damage, serious bodily injury and death. SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
Drawings or sketches are not contractual and can change according to the models
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered trademarks of ERICO International Corporation
TECHNICAL SUPPORT www.erico.com IP8323A4_A 1 of 7 2015 ERICO International Corporation
ERICO® FLEXIBAR®
Manual ERICO FLEXIBAR Shearing Tool
559146 MFSHT-2
ERICO FLEXIBAR Sizes [mm]: 8 x 6 x 0.5 5 x 32 x1
A. Workbench:
4x 11mm
For ERICO® FLEXIBAR®
ONLY
100mm
100mm
Max
5 mm
Max
32 mm
INSTRUCTION SHEET
TECHNICAL SUPPORT www.erico.com IP8323A4_A 2 of 7 2015 ERICO International Corporation
B. 2 positions of the handle:
or
or
INSTRUCTION SHEET
TECHNICAL SUPPORT www.erico.com IP8323A4_A 3 of 7 2015 ERICO International Corporation
2.
B. Cut ERICO FLEXIBAR :
C. Make chamfrains on ERICO FLEXIBAR :
1
.
3. 4.
L
1
.
2
.
0 300 mm
INSTRUCTION SHEET
TECHNICAL SUPPORT www.erico.com IP8323A4_A 4 of 7 2015 ERICO International Corporation
2. a)
a
0 < a < 15mm
3. a)
2. b)
3. b)
a 0 < a < 15mm
45°
45°
45°
INSTRUCTION SHEET
TECHNICAL SUPPORT www.erico.com IP8323A4_A 5 of 7 2015 ERICO International Corporation
6. a)
4. a)
5. a)
4. b)
5. b)
6. b)
INSTRUCTION SHEET
TECHNICAL SUPPORT www.erico.com IP8323A4_A 6 of 7 2015 ERICO International Corporation
D. Maintenance:
1. Remove the chips:
2. Change the blade:
6 mm º
new
1. 2. 3.
4. 5. 6.
6 mm
INSTRUCTION SHEET
TECHNICAL SUPPORT www.erico.com IP8323A4_A 7 of 7 2015 ERICO International Corporation
3. Change the fixe blade or Rubber:
4. Regular checking + oil :
1. 2. 3.
6 mm 20 N.m MAX
NO
Rubber
YES
Rubber
Torque : 80 N.m
OIL OIL