picker and picker base
TRANSCRIPT
Picker and Picker Base
Revision Date / Version: 3/20/2014 - 2
Installation Directions for the Picker and Picker Base.
Picker Picker Base for Dual Function, C and E series.
TOOLS NEEDED
Phillips Screw Driver
Flat Head Screw Driver
Needle Nose Plyers
2.5mm T Handle allen wrench.
Part #: 08021PR-T121 Part #: AS-001429-03
Picker and Picker Base
Revision Date / Version: 3/20/2014 - 2
Picker Base
1-Remove the Phillips screws from the Picker Base to release the Picker. (Fig 1)
2-Remove the Black flat Head Screw from the Picker Sol Link. (Fig 2)
3-Remove the E Ring from the shaft of the Picker Base and pull out the defective Picker Base from the
Picker bracket. (Fig 4)
4-Insert the new Picker Base into the Picker Bracket Cylinder. Fig 5
5-Place the E ring back into the Picker Base shaft. Fig 6
6-Insert the Black flat Head Screw through the Picker sol link hole and tighten the screw into the Picker
Base. Fig 7
Fig 1
Fig 4 Fig 3
Fig 2
Picker Sol Link
Picker Bracket
Fig 6 Fig 5 Fig 7
Picker and Picker Base
Revision Date / Version: 3/20/2014 - 2
Picker
1-Mount the Picker back on to the Picker Base and only snug the phillips screws into the picker Base.
2-Do not tighten the screws yet, we need to do a proper Picker alignment.
3-Push the Picker towards the Bobbin in the Rotary Hook (Fig 3) and make sure the two Prongs touches
the bobbin and the Pig Tail of the bobbin is in between the two Prongs. (Fig 4)
4-Tighten the Phillips screws as you hold the Picker in towards the bobbin, after the screws are tighten
you can release the Picker.
5-Picker Stopper can be adjusted if needed to get the Picker closer to the Bobbin. (Fig 5)
Fig 1 Fig 2
Fig 3 Fig 4
Fig 5 Picker Stopper
Picker and Picker Base
Revision Date / Version: 3/20/2014 - 2